Acu-Rite 150 manual Senc Mounting Preparation, Cable direction

SENC 150						Mounting Preparation
Please follow these preparation guide lines.
• Understand your mounting requirements.
• Mount with lip seals down and away from the work area.
• Brackets should be kept as short as possible and rigid.
• Surfaces must be in good condition, clean, and free of dirt.
	Remove paint from machined mounting surfaces.
• Alignment brackets must not be removed until instructed.				1.150	1.150
				“L”
				“L” = Measuring length + 1.75” nominal over travel
		• Machine travel can not exceed the encoder measuring length.
		•		Either limit machine travel or obtain correct length scale.
			Cable direction				Vinyl cable grommet
				Cover plate
					Plug
						Armor cable hex crimp
				T-10 Torx screw (2)
			• Determine cable exit direction before installing the encoder.
• Never mount with lip seals upward or towards work area.			• To change the cable exit direction; remove the cover plate and
				rotate the cable 180°.
3								ACU-RITE®

516291-21_Ve00_SENC_150.indd 5

10/22/2009 10:00:39 AM