Installation
Step by Step
1.The TS120 is a small
2.Run the cable to the TS120. Label the cable for future reference.
3.Locate the connector on the TS120 and remove it.
4.Next, strip 1/4” of insulation from the end of each wire. Tightly twist the end of each wire until there are no frayed ends.
5.Use a small flathead screwdriver or your thumbnail to raise the locking tabs, exposing the holes on the removable connectors.
Figure 4 This color code is based on the industry standard T568A coding for the RJ45 connector. When connecting the TS120 to Niles MultiZone Keypads with an IR connection observe this pin configuration
NILES AUDIO CORPORATION – | 7 |