Niles Audio TS120 IR Test LED Off, IR Test LED On or Flickering, EMI Electromagnetic Interference

Page 14

TROUBLESHOOTING (continued)

IR Test LED Off:

Optical Interference

IR Test LED On or Flickering:

Electromagnetic and/or Optical Interference

EMI (Electromagnetic Interference)

Identify the source of the interference. The most common sources of electromagnetic interference are listed in the Installation Considerations section. To eliminate EMI try the following methods:

1.Move the sensor or the sensor cable away from the EMI source or move the source of the EMI away from the sensor or the cable.

2.Connect the Sensor’s GND terminal to true earth ground (if this isn’t feasible use the main system unit’s GND terminal).

There are many methods for reducing interference. Which solution is best for you depends on your situation. If you require further assistance call Niles Technical Support at 305-238-4373 or

1-800-289-4434 (M-F 8:00 AM - 7:00PM ET). You can also email Niles Technical Support at support@nilesaudio.com.

12

Image 14
Contents TS120 Table of Contents CongratulationsCONTents IntroductionFeatures and Benefits TS120 Mounting Location Installation ConsiderationsType of Cable Avoiding Electrical Interference Installation ConsiderationsReceiving Range and Pickup Angle Avoiding Optical FeedbackUsing the Power Status Display Avoiding InterferenceParts guide Installation Step by StepInstalling the removable connector Blue Feedback LED Green Power Status LEDOperation Troubleshooting Identifying the Type of Interference TroubleshootingEliminating Optical feedback EMI Electromagnetic Interference IR Test LED OffIR Test LED On or Flickering Specifications Page Niles Audio Corporation 1-800-BUY-HIFI Limited Warranty Warranty Registration Card Miss MrsL e s a u d i o C o r p o r a t i o n