Niles Audio IR-KIT manual Installation, See installation diagram

INSTALLATION

1.Select an appropriate location for the IR-CB2.

2.Run all the necessary wiring to the IR-CB2. Label the wires for future reference.

3.Plug the supplied 12V DC power supply into the un-switched AC outlet.

4.Plug the 12V DC power supply connector into the IR-CB2 socket marked POWER.

5.After verifying that the AC outlet works, unplug the power supply connector.

6.Determine the mounting location for the IR-SMR.

7.Make sure the mounting surface is clean.

8.Remove the protective coating from the self- adhesive tape and attach the IR-SMR to the mounting surface.

9.Run the IR-SMR cable. Label the cable for future reference.

10.Locate the IR Connecting Block Snap and Lock Connectors and remove them if they are plugged in.

11.Use a small flathead screwdriver or your thumb to

raise the locking	(White)	(Yellow)	(Black)
tabs, exposing the			(Red)
holes on the
connectors.			Figure 1
12. Insert each wire into
the appropriate hole
and snap down the locking tabs. Figure 1

13.Insert the smooth side of the connector plug into the smooth side of the IR Connecting Block socket.

14.Connect the IR-E1 Emitters to the emitter outputs.

15.Plug the 12V DC power supply connector into the IR-CB2 socket marked POWER.

See installation diagram (page 6).

5