Woods Equipment BH9000 manual Mount Sub-Frame & Backhoe to Tractor

Page 13

SUB-FRAME & BACKHOE INSTALLATION TO TRACTORWWARNING

Mount Sub-Frame & Backhoe to Tractor

νThe sub-frame mount is designed to provide secure mounting and adequate operator clearance when properly installed. Check clearance dimen- sions shown in figure 1 to be sure you have installed sub-frame correctly. Follow all mounting instruc- tions in this manual. Do not operate backhoe unless there is adequate clearance. Failure to check and comply with these instructions may result in serious injury or death.

νThe only time the backhoe may be operated from a position other than the operator seat is during backhoe attachment and removal. Operator must

Read Operator's Manual instructions on attach ing an d removing backhoe and use extreme care

Engage swing lock to prevent boom rotation

Always stand rearward of backhoe stabilizer arms or along side of tractor to avoid being trapped should the boom swing control be acci- dentally activated.

νRemove seat and upper support assembly before installing or removing backhoe from tractor. Failure to comply may result in equipment failure and/or personal injury.

1.Remove the backhoe seat assembly.

2.Place sub-frame flat on a hard level surface.

3.Back tractor over the sub-frame and center between the tractor rear tires. Position tractor so that the hydraulic system can be connected

4.Use the backhoe hydraulics to maneuver the sub-frame into position for hook-up. Use care in this procedure to avoid being trapped between tractor and backhoe or between backhoe parts.

5.Raise sub-frame up by lowering stabilizers and boom section until cross tube is level with rear mounting bracket channel.

6.Shut off tractor. Roll tractor back so tube slides into channel.

7.Fasten sub-frame in place by placing clevis pins into channel holes and secure with safety pins.

8.With the tractor engine off, relieve pressure in the backhoe boom to raise sub-frame into front hanger.

9.Install bent pin and klik pin.

MAN0047 (9/15/00)

INSTALLATION 11

 

 

 

Image 13
Contents MAN0047 To the Dealer Model #1001378 Sub-Frame Mounting Kit Date of PurchaseSafety Rules SafetyInstallation TrainingOperation MaintenanceBackhoe SUB-FRAME Installation InstallationTractor Preparation SUB-FRAME Installation Cont’dFront Support Installed Install Front SupportInstall Cross Member #1001387 Sub-Frame Fit-Up Torque SpecificationsAttach Sub-Frame to Backhoe Pump Bracket Installation Install Pump Kit #9504Connect Hydraulic System Pump KIT InstallationMount Sub-Frame & Backhoe to Tractor Attach Top Link SUB-FRAME & Backhoe to TractorRemove Backhoe With Sub-Frame Hydraulic Pump Storage Store Hydraulic Pump#1001378 SUB-FRAME Mounting KIT PartsSAE Series Torque Chart Bolt Torque ChartAppendix Metric SeriesAbbreviations Bolt Size ChartWarranty Model No Part Warranted Duration MAN0047