SUB-FRAME INSTALLATION Cont’d
Install Right and Left Rear Supports
Right Rear Support #1001380
Left Rear Support #100381
1.Install right rear support by inserting cap screw
(1) and flat washers (2) into position as shown in Figure 6.
NOTE: Install flat washers between rear support and pivot pin and on outside at head of cap screw as shown in Figure 5.
2.Install cap screw (3) and flat washer (2) in front hole(Figure 6). Only use one flat washer on outside at head of cap screw.
3.Install remaining two cap screws (1) and four flat washers (2) into position around pivot pin. Install flat washers both inside and outside of rear sup- port.
4.Install two cap screws (4) and flat washers (5) into bottom of tractor chassis as shown in Figure 7
5.Install left rear support, following steps
Install Cross Member #1001387
6.Install cross member between right and left rear supports using four cap screws (3), flat washers (2) and hex nuts (6) as shown in Figure 7.
1.1001575 M14 x 2.0P x 55mm Cap screw
2.46070 9/16 Flat washer, hardened
3.33125 M14 X 2.0p X 50 mm Cap screw
4.30743 M16 x 2.0P x 45mm Cap screw
5.57817 5/8 Flat washer, hardened
6.307825 M14 x 2.0P Hex nut
2
1
Figure 5 Flat Washer Installation on Rear Support
Pivot Pin |
1
23
2
Figure 6 Right Rear Support Installed
5 4
2 3 6
Figure 7 Rear Supports & Cross Member Installed
6 INSTALLATION | MAN0047 (9/15/00) |
|