Woods Equipment BH9000 manual Sub-Frame Fit-Up, Torque Specifications

SUB-FRAME INSTALLATION Cont’d

Sub-Frame Fit-Up

1.Center sub-frame under tractor.

2.Insert cross tube of sub-frame into channel of rear support as shown in Figure 8.

3.Install clevis pins (1) and hair pins (2) to secure sub-frame and rear supports as shown in Figure 8.

1.37827 Clevis pin.75 x 3.14

2.2688 Hair pin 5/32

1

2

Figure 8 Clevis Pins Installed

4.Rotate sub-frame up until locating lugs are posi- tioned on the outside of front support.

5.Align holes and install bent pin (3) and klik pin 4

as shown in Figure 9.

6. Once sub-frame is secured into position, tighten all hardware to torque specifications.

7. Remove sub-frame from tractor.

3.	54088 Bent pin
4.	62043 1/4 x 1-3/4 Klik pin				4
					3
						Figure 9 Bent Pin Installation
		TORQUE SPECIFICATIONS
				Wrench
		Cap Screw	Qty	Size		Required Torque
		M14 x 2.0 x 50mm	10	21mm		80 lbs.-ft.(109 N-m)
		M14 x 2.0 x 55mm	6	21mm		80 lbs.-ft.(109 N-m)
		M16 x 2.0 x 45mm	4	24mm		125 lbs.-ft.(169 N-m)

MAN0047 (9/15/00) INSTALLATION 7