Woods Equipment 1028310 Install 1029700 Mount Kit, For New Holland Loader Mount Only

Install 1029700 Mount Kit

For New Holland Loader Mount Only

This mount kit is needed to connect sub-frame mount- ing kit 1028310 to the New Holland 620TL loader mount.

1.	Remove toolbox and toolbox bracket from the
	right loader mount if equipped.
2.	Attach right backhoe bracket (1) to the inside of
	New Holland loader mount and toolbox bracket
	(3) to the outside of loader mount.
3.	Secure using two cap screws (4), hardened flat
	washers (5), one tube support (7) and two flange
	lock nuts (6).
	NOTE: Tube support (7) is placed between the

Figure 3. Right Backhoe Bracket Installation

	two rear holes on the mount.
4.	Attach toolbox to toolbox bracket (3) using hard-
	ware previously removed.
5.	Repeat steps to install left backhoe bracket (2) to
	left loader mount. See Figure 5.
	1.	1029702	Right backhoe bracket
	2.	1029703	Left backhoe bracket
	3.	1029704	Toolbox bracket

1

73

4.	300469	5/8 NC x 6-1/2 HHCS GR5
5.	57817	5/8 Hardened flat washer
6.	19025	5/8 NC Flange lock nut
7.	1029774	Tube support

6

4

DP7

Figure 4. Right Backhoe Bracket Installed

7

2

6

4

Figure 5. Left Backhoe Bracket Installed

6 Installation MAN0715 (rev. 10/31/2008)