Woods Equipment 1028310 Backhoe SUB-FRAME Installation, Tractor Preparation

BACKHOE SUB-FRAME INSTALLATION

Tractor Preparation

■Only use 1028310 4-Point Sub-Frame Mount-

ing Kit for mounting Woods BH90-X backhoe on New Holland® TT60A or TT75A tractors equipped with Woods LU126 loader. Use mount kit 1029700

and 1028310 Sub-Frame Mounting Kit to mount Woods BH90-X backhoe on New Holland® TT60A or TT75A tractors equipped with New Holland 620TL Loader. Any other use or modification of this mounting kit may result in serious injury or death.

For installing this sub-frame, references to right, left, forward and rearward directions are determined from the operator’s position in the tractor seat.

Do not install 1028310 4-point sub-frame on a tractor without a Woods or New Holland loader mount attached.

Refer to the WOODS BH90-X Backhoe Operator’s Manual for backhoe assembly instructions.

Leave all hardware loose until sub-frame has been fit up or otherwise specified in the instructions.

1.Place jackstands under rear axle and remove both rear tires.

2.Disconnect the tractor anti-sway links from the axle brackets. Secure sway links to the drawbar bracket with sway link pins and safety pins (22) supplied in kit. See Figure 1.

3.Remove top link.

4.Remove the lower ROPS bracket from the bottom of the rear axle (Figure 2). Leave ROPS bolts in place.

NOTE: Only work on one side of the tractor at a time. ROPS may become unstable if both ROPS brackets are removed at the same time.

5.1028360 Hose Kit Only: Disconnect the loader valve PBY hose from the tractor steel hydraulic line under the right side of the operator’s platform.

6.Disconnect the steel hydraulic line from the hydraulic valve at the rear of the tractor and remove the hydraulic line. See Figure 2.

DP1

Figure 1. Reposition Anti-Sway Links

Remove

Remove

DP2

Figure 2. Remove Hydraulic Line & ROPS Bracket

(Right Side Shown)

As a valued customer, Woods appreciates your comments. Once sub-frame and hydrau- lic hoses have been installed, please take a few minutes to complete the Sub-Frame Mount Evaluation sheet that was supplied with your sub-frame. Your comments will help us continue to bring you quality products.

MAN0715 (Rev. 10/31/2008) Installation 5