Woods Equipment 2300003 Loader Mount Installation, Remove Exhaust Bracket, Nord-LockWasher

LOADER MOUNT INSTALLATION

TRACTOR PREPARATION

■Only use this mounting kit for mounting Woods LU132 or LU132-2 loader on Case IH® JX1085C and

JX1095C or New Holland® TN85A, TN95A, TN85DA, TN95DA tractors. Any other use or modification of this mounting kit may result in serious injury or death.

NOTICE

■This equipment must be assembled and installed on the customer’s tractor by the Woods dealer. Dealer must thoroughly inspect equipment and complete each item on the PRE-DELIVERY CHECK LIST, DELIVERY CHECK LIST, and PROD- UCT REGISTRATION from the loader manual before equipment is released to the customer.

NOTICE

■Clean threaded holes in the tractor chassis thor- oughly using a tap of the proper size. Paint, rust, or debris in the threads may not permit cap screws to be installed and tightened correctly.

For installing this mounting kit, references to right, left, forward, and rearward directions are determined from the operator’s position in the tractor seat.

1.Shut off engine and set parking brake during instal- lation.

2.Remove the tractor front weights if equipped.

3.Leave mounting hardware loose until loader mounts are completely installed.

Remove Exhaust Bracket

ROPS Tractors Only

1.Remove exhaust pipe from muffler and exhaust bracket.

2.Remove exhaust bracket from tractor.

3.Place two washers (7) between heat shield bracket and tractor. Secure with bolt removed with exhaust bracket.

NOTE: Washers (7) are included in exhaust relo- cation kit 1024092.

7. 44546 3/8 Hardened flat washer

Place Washers (7) Behind Heat Shield

Exhaust

Bracket

DP5

Figure 1. Remove Exhaust Bracket

Nord-Lock®Washer

The Nord-Lock®washer is a unique bolt securing sys- tem that uses tension rather than friction. When the bolt and/ or nut is tightened, the teeth grip and seat the mat- ing surfaces. The wedge locking effect created makes the bolt self-locking.

The advantage to the Nord-Lock washer is that it achieves maximum security when locking fasteners. These washers resist loosening caused by vibration or dynamic loads. They are easy to install and remove and provide positive locking at low and high preload levels. They are reusable if lubricated before reuse.

Nord-Lock	Through	holes	Nord-Lock		can
secures bolts in			not	be used on
	require two pairs
tapped holes.			washers that are
	of NL washers.
			not	locked	in
			place

Figure 2. Nord-Lock Washer

4 Mount Installation MAN0572 (Rev. 1/30/2009)