5.3.9. Upgrade RA & DEC
Use this operation to upgrade 8408 hand controller, R.A. and DEC motor controller firmware. Please refer to iOptron online documents for ZEQ25 firmware upgrade details. The password is 9999.
5.4. Align
This function is used for aligning the telescope. The hand controller provides “Polar Align”, which uses a set of 2 bright stars for polar alignment. This provides a viable polar alignment approach for those who can’t see the polar star or has a mount does not equip an iOptron AccuAlignTM polar scope. The system also provides three alignment methods: “SolarSys Align”, “One Star Align”, and
5.4.1. Polar Alignment
Press the MENU button, then select “Align” and “Polar Align”. The HC will display the azimuth and altitude position of several bright stars near meridian. Select one that is visible with high altitude as Alignment Star A. Follow the HC instruction to move the Star A to the center of the eyepiece with the combination of Latitude Adjustment Knob and “◄” or “►” button. Press ENTER to confirm. Next, select a bright star that is close to the horizon as the Alignment Star B. Center it using the Azimuth Adjustment Knob and “◄” or “►” button (The “▲” and “▼” buttons are not used here). Press ENTER to confirm.
The telescope will now slew back to Star A to repeat above steps. The iteration can be stopped when it is determined that the alignment error is at the minimum. Press BACK button to exit alignment procedure.
NOTE: It is highly recommended to use an eyepiece with
NOTE: The movement of the alignment star in your eyepiece may not be perpendicular but crossed, depends on its location in the sky.
5.4.2. SolarSys Alignment
Press MENU button and select “Align”. Select “SolarSys Align” and press ENTER for available alignment object.
5.4.3. One-Star Alignment
Press MENU button and select “Align”. Select “One Star Align” and press ENTER. A list of alignment stars that are above the horizon is computed based on your local time and location. With the mount at the “Zero Position,” use ▲ and ▼ buttons to select a star and press ENTER. Center the target in your eyepiece using arrow key. Press ENTER when finished. If your mount is well set up and polar aligned, one star alignment should be sufficient for good GOTO accuracy. To increase the accuracy you may choose to do multi star alignment.
5.4.4. Multi-Star Alignment
With iOptron’s
Press MENU button and select “Align”. Select
25