WARNING: Please DO NOT rock the counterweight shaft rigorously. You’ll degrade the performance of the spring loaded gear meshing system, or even damage it.
WARNING: The new Gear Switch will allow you to have most precise weight balance. This also means the mount or OTA will swing FREELY when the Gear Switch is disengaged. Always hold the OTA or mount when release Gear Switch or adjust gear tension.
WARNING: DO NOT fully lock the 2 Tension Adjusters during operations.
NOTE: The mount is shipped with latitude setting at high range (35º ~ 60º). If your site latitude is lower than 35º, please switch the latitude range before using.
STEP 1. Select Mount Latitude Range
Carefully remove the mount from the shipping box and familiarize yourself with the components shown in Figure 1.
The mount is by default shipped with the Long Latitude Adjustment Knob installed (for
Short Lat. Adj. Knob | Level Bubble | Latitude Indicator |
| ||
|
| |
| Long Lat. Adj. Knob | For Low Latitude |
|
| |
| Lat. Locking | For High Latitude |
|
| |
Bottom Lat. Adj. Post |
|
|
Locking Screw | Azi. Adj. Knob |
|
|
|
(a) | (b) |
Figure 7. Switching latitude adjustment knob
STEP 2. Tripod Setup
Expand the tripod legs. Adjust the tripod height by unlocking and
There are two threaded holes on the tripod head for alignment peg installation. The Alignment Peg may be moved to the opposite position shall the mount hit the tripod leg when used at a high latitude.
11