Alignment Peg
Center Rod Knob Accessory Tray
Tray Locking Knob
Figure 8. Set up tripod
STEP 3. Attach the ZEQ25 Mount
Retract both Azimuth Adj. Knobs to allow enough clearance inside the chamber. Position the mount on the tripod head with the Alignment Peg in between the 2 Azimuth Adj. Knobs. Thread the Center Rod into mount to secure it with tripod. Tighten the Tray Locking Knob to fully spread the tripod legs. Adjust the tripod legs to level the mount using the Level Bubble.
Azi. Adj. Knob
Alignment Peg
STEP 4. Adjust Latitude
This step requires you to know the latitude of your current location.
This can be found from your 8408 hand controller after the embedded Figure 9. Attach a mount GPS receives the signal from the satellites. It also can be easily found on
the Internet, with your GPS navigator or a GPS capable cell phone. You
will have to change this latitude setting every time you significantly change your night sky viewing location. This setting directly affects the mount’s tracking and GOTO accuracy.
Slightly loosen the Latitude Locking
STEP 5. Install Counterweight (CW) Shaft
CW Mounting Nose
Front CW Position Screw
(1)
(3)
(2)
CW Shaft Locking Screw
Figure 10. Install counterweight shaft
12