Remote Relay Module

INSTALLATION INSTRUCTIONS

CC62

The CC62 Remote Relay Module consists of six double-pole double-throw relays which are controlled by way of IR commands from a Xantech RC68+ (or RC68) Programmer. The RC68+ commands are "taught" to learning devices and passed to the CC62 IR IN (S) and G input terminals via Xantech IR receivers, keypads, etc. The six relays give "dry contact" closures for a multitude of uses where simple contact closures are needed. Any combination of one to six relays may be selected and operated in several ways using the commands from the RC68+ Programmer.

CC62	RELAY	RELAY	RELAY	RELAY	RELAY	RELAY
REMOTE RELAY MODULE	1	2	3	4	5	6

		NO	NO	NO	NO	NO	NO
		NC	NC	NC	NC	NC	NC
	IR CONFIRM	NO	NO	NO	NO	NO	NO
IRIN	GND GND +12V
		NC	NC	NC	NC	NC	NC

12VDC 1A

Fig. 1 The Model CC62 Remote Relay Module

FEATURES AND SPECIFICATIONS

•6 double-pole double-throw relays rated at 5 Amps. 30 volts DC.

•2 normally open and 2 normally closed contacts per relay.

•Six 6-terminal screw-type plug-in connectors - one for each of the relays.

•Each relay and the relay poles are isolated from each other allowing use in circuits of differing potentials and grounds.

•4-terminal IR IN and +12V plug-in for Xantech IR Receivers, Smart Pads, connecting blocks and other devices.

•IR Confirm LED lights with RC68+ and non RC68+ IR signals.

•RC68+ IR commands permit Pair, Toggle, Momentary and Group mode operations as well as different IR codes for use of multiple CC62's.

•The CC62's Code Group number is 60.

•Universal mounting fits 19-inch racks or any 3-1/2" X 19" flat surface. Extends about 2-3/4" behind panel with cables connected.

•Requires RC68+ (or RC68) Programmer and 782-00 Power Supply.

•Power: 12 VDC @ 300mA.

•Dimensions: 19" W x 3-1/2" H x 2-1/4" D

RC68+ PROGRAMMER / REMOTE CONTROL

The RC68+ Programmer (available separately) contains all commands necessary to operate the CC62 (see Fig. 2).

•You will need it to program universal learning devices such as the Xantech URC-1 learning remote, the Xantech Smart Pads, the 590 Controller, the 710 Fone Link, etc., with commands that operate the CC62.



Remote Control Switchers