Xantech Code Group Setting Procedures, Setting the RC68+ Code Group Number

CODE GROUP SETTING PROCEDURES

Use these procedures to:

a)Select the Code Group Number on the RC68+ to match the Code Group Number internally preset at the factory for the specific Xantech model you wish to control.

b)Change the Internal Code Group Number of a Xantech model. You would do this to avoid mutual interaction when using two or more of the same model on the same IR network (bus).

Setting the RC68+ Code Group Number

1.Using the chart below, determine the factory preset Code Group Number you need to operate a specific Xantech model. Since these numbers are also provided in the Installation Instructions for each model, refer to them for newer models that may not be listed below.

Model	Code Group Number
680-10	88
686-10	98
AC2	28
CC12	50
CC62	60
GATEKEEP-IR	C8
IR-DC4	D1, D2, D3
MIRV1	30
RAT1	30
RGC11	30
RP41AV	40
RS41AV	20
SmartPad3	D8
SR21	50
RT8	58
RT16-10	70
ZPR68, ZPR68-10	68

RC68+

(rear

panel)

1st Digit

(Left)

							8		9			A
						7
			5		6							B
														C
			3												D
		4												E
						2						F
							1	0
CODE GROUP
		8	9	AB								8	9	AB
5	6	7							5	6	7
						C									C
3							D		3							D
4						E			4						E
		2	0	F							2		0	F
		1										1

		8		9	A
		7
5	6				B
						C
3							D
4						E
		2			F
		1	0

2nd Digit

(Right)

FIG. 4 Setting the code switches (68 shown for the ZPR68)

2.Using a small blade screwdriver, rotate the two Code Group setting switches on the rear of the RC68+ (see Fig. 4) to the Code Group number noted from the previous chart. The Left switch is the first digit in the number and the Right switch is the second digit.

3.The Xantech model should now respond to the RC68+ commands that relate to that device (i.e., volume up/down, input selection, etc.). Fig. 4 shows the switches set to 68, the Code Group number for the ZPR68.

CHANGING THE INTERNAL CODE GROUP NUMBER OF A XANTECH MODEL

1.Connect a Xantech IR receiver (Model 780, 480, etc.) to the IR terminals of the Xantech device you wish to change (RAT1/MIRV1, RT16-10, etc.) along with the correct power supply.

Do not connect other Xantech models at this time.

CAUTION: You must connect each device separately when setting the code group, otherwise they will all respond to the same code after the change is implemented!

NOTE: The exception to this is when you intentionally want two or more units to respond to the same code. This would be the case, for example, when using a MIRV1 with a RAT1. These two units must be set to the same code so that they will respond to each other as well as to the RC68+ commands.

4 

RC68+