HDD Control
Checking the Hard Disk Drive
You can check the free space of the hard disk drive, and can format the disk drive if necessary.
1.Press the MENU button.
2. | Select Recording using the ̵/̷ button, and press the OK or button. |
3. | Select HDD Control using the ̵/̷Gbutton, and press the OK orG button. |
4.Select Internal Device or External Device (if connected) using the GGGG / Gbutton.
5.You can check the total, TSR buffer, recorded and free space of each HDD.
6.Select Diagnosis and press the OK button to diagnose the HDD. Diagnosing progress bar appears. After finishing diagnosing, confirm the message and press the OK button.
7.Select Format and press the OK button to remove all the recorded programmes saved on the HDD and initialize the HDD.
8.Select Yes and press the OK button for the format confirm message, and then is started formatting the HDD. Formatting progress bar appears. To abort formatting, select Cancel and press the OK button, and then select Yes and press the OK button.
Note :
_You have to be careful because performing format deletes all the recorded programmes saved on the HDD.
_In case of External Device, Remount or Disconnection menu appears. Please connect/disconnect safety using these menus.
_The file format of external device must be FAT32 or Linux file format for copying to external device. If the file format of external device is mismatched to these file format, you should initialize the external device at
_Don't unplug the power cord during format. If you did unplug it, you shoud perform the format again.
In HDD Control, you can move easily to the Recorded Programmes or Recording Schedule using the RED or GREEN buttons on the remote control.
43. HDD Control