Gefen GTV-WHD-1080P-SR manual Operation Notes

Page 8

OPERATION NOTES

Continued from previous page

»» EU Models: Up to 2 pairs of Sender and Receiver units can be operated in the same environment. Local RF interference can limit the number of units that can be used. Each Sender unit needs to be placed at least 1 meter apart for optimum performance. If additional Sender / Receiver pairs are to be used, each set of units must be placed beyond the reception range (80 feet / 25 meters) of each other in order to prevent interference.

IR back-channel compatibility:

»» Only products with 38 kHz IR carrier frequency are compatible. If in doubt, please check with the equipment manufacturer.

»» Due to complexity in some manufacturers’ IR codes, not all 38kHz IR devices may be compatible with the IR Back Channel of the Wireless for HDMI. The following brands have been tested by Gefen: Panasonic, Sony, and Samsung.

Operational Limitations:

»» Regarding US and EU models, note that all RF devices are designed by compliance regulation to accept interference from all other devices. Operation of wireless products is therefore dependent on the environment they are in. Other RF products, even ones that seemingly might not be in the frequency range, do create harmonics and other artifacts that could interfere with the operation of the Wireless for HDMI.

4

Image 8
Contents Wireless for Hdmi Page Wireless for Hdmi In-Room Solution Asking for AssistanceTechnical Support Technical Support HoursContents About Gefen GefenTV Wireless for Hdmi In-Room Solution IntroductionFCC Statement Instruction to the UserOperation Notes Operation Notes Features Hdmi Features SupportedFeatures Package IncludesPanel Layout Receiver unit Front Back Receiver Unit Panel DescriptionsSender Unit IR Remote Control Unit Layout and DescriptionsWiring Diagram for the Wireless for Hdmi In-Room Solution Connecting the Wireless for HdmiHow to Connect the Wireless for Hdmi In-Room Solution Operating the Wireless for Hdmi Linking ProcessUsing Multiple Sender Units Adding a new Video SourcePress the OK button to continue adding the Sender unit Adding Sender Renaming Sources Available characters for source naming Select Video Source Sender Switching between Sources STB Deleting Sources After a few seconds, the screen will go blank DVR Connecting to... status message will be displayed Disconnecting the Wireless Link Reconnecting the Wireless Link Power-Down Mode Powering-Up after a Power-Down Specifications Warranty Product RegistrationPage Page Rev A5 Nordhoff St., Chatsworth CA