DirecTV HD65W20 manual Using the Input Button, Input source

Basic TV Operation

Using the INPUT Button

VCR1 ON • OFF TV

1.Repeatedly press the INPUT button to scroll through the available input sources until you find the input associated with the component (such as VCR or DVD player) you want to view.

Input source

DVD	VCR2 AUX DIRECTV
MUTE	SKIP
	CH +
L	V
O	O
V	L
	CH -
FETCH	GO BACK

GUIDEINFO

OK

Watch the channel banner to see the input sources change with each press of the INPUT button.

2.Once you have found the input source you want, stop pressing INPUT.

•If you tune to VID1 and your VCR is connected to that input, you will be able to view your VCR. To play, stop, or rewind the VCR1 tape using the remote that came with your TV, you must first press the VCR1 button to put the remote control in VCR mode.

There are other ways of selecting an input channel:

•Program the component (VCR, DVD, etc.) buttons on the remote control to automatically tune to the correct input channel when pressed. See the section in this book, “System Options and Preferences“ for information on auto tuning.

•After pressing INPUT on the remote, enter the digits 1, 2, 3, 4, or 5 to tune to (S)VID1, 2, 3, FRONT, or CMPNT, respectively.

•After pressing INPUT on the remote, press GUIDE on the remote control to view a guide-like list of your line inputs and corresponding channels.

INPUT button

MENUCLEAR

1 2 3

4 5 6

7 8 9

INPUT		ANTENNA
0
REVERSE	PLAY	FORWARD
RECORD	STOP	PAUSE

PIP SWAP CH CTRL WHO

32 Chapter 3