Setting the Product Up
Set Your TV’s Input to HDMI
Turn your TV on. Using the remote that came with your TV, set the input to the HDMI port to which the ScreenCast is connected. You should see the ScreenCast language selection screen on your TV:
TV INPUT: HDMI
INPUT
OK
Use Your ScreenCast AV Remote to Select Languages
Use the up and down buttons on the remote to move the pointer to your choice, and then press “OK.”
Name Your Video Sources
After the language choice, ScreenCast will show you each of your video sources in turn. This will give you a chance to pick a useful name from a list of common video source names. After this step, you are done with setup.
Setting Up the IR Emitters
Determine where your video sources receive commands from their remotes. This will usually be some sort of lens on the front panels of the device. These receivers are known as “IR,” since they receive an infrared signal.
To determine the location, use the remote that came with each device, and press a button as you are pointing at the device. Try to move
the remote as close as possible to find out the exact location of the receiver.
Position each IR emitter end so that its small domed lens is pointing at the IR receiver on the source device. Then point the device’s remote at the ScreenCast receiver and press a button. If nothing happens, adjust the aim of that emitter until it works.
11