Connectivity

Troubleshooting and FAQs

What do the LEDs on the receiver mean?

Most of the information you need will appear on the TV screen, but here’s a short list of what the LED light on the transmitter and receiver can tell you.

When your ScreenCast	The light will be…
unit is…
Starting up	Slowly blinking blue

Establishing a	Rapidly blinking blue until the connection
connection	is made. If the connection cannot be made
	after one minute, the light will blink amber to
	show that a connection failure has occurred.

Connected with good	Solid blue
signal strength
Connected with poor	Solid amber
signal strength
Receiving input from	The light will rapidly turn on and off until the
the remote control	remote button is released.

How long will it take for my ScreenCast AV system to “wake up” and connect?

•When turning on the receiver and transmitter, it can take up to 15 seconds for the devices to connect with one another.

•If you change sources or video resolution, you may experience up to 10 seconds of connection time as the devices sync with one another.

•If you are adding an additional transmitter to your ScreenCast

AV system, it can take up to 60 seconds to pair.

Note: The ScreenCast AV system comes with the receiver and transmitter pre-paired so this should not be necessary unless you add an additional WHDI™ transmitter or press the reset button long enough to reset the receiver to factory defaults (5 seconds or more).