Aurora Multimedia ICS-SP20 manual Troubleshooting, Symptom Checks

Page 13

ICS-SP20 User Manual

If the password is reset, the user is prompted to enter new password on his/her first access to V-Chip limit. For all subsequent accesses the user will have to use the password that was specified during the first access. In the event the password is forgotten the V-Chip settings can reset by holding the enter button for 5 sec. When prompted for the password enter right, left, right, left, enter and it will be reset to default values.

7.10 Troubleshooting

Symptom

Checks

Key on remote is pressed but

See if the upper LED of ICS-SP20 is fast-blinking while

nothing happens

pressing key and aiming remote at IR sensor on the display.

 

If it is not -– check the batteries in the remote.

Image is Green

Make certain Option slot is select to YPbPr

No control of the display via

Under panel settings check to see if correct model is

Menus

selected.

No Image

Check to see if Option Slot is selected as source

Cannot switch to a particular TV

The channel is selectable by browsing keys only if it is

channel using channel +/-

marked as “valid”. To be marked as “valid” the channel must

browse keys.

have a good TV signal during the “channel scan” operation.

 

Repeat the channel scan (making sure aerial/cable

 

connection is good). Also the channel validity can be edited

 

manually.

 

 

12

Image 13
Contents ICS-SP20 for Sony Table of Content Supported IR transmitters and basic key functions IntroductionQuick Start Guide Sony Display SettingsLED functions RF connector A/V & Control connectorsRJ11 Service Port connector ConnectionsKey Volume+/- VOL Remote Control FunctionsOperating the ICS-SP20 Key Contrast +/- CHKey ID OFF KeysKey Chroma Key ON/STBYVideo Settings General SettingsTuner Settings Audio SettingsVolume Spatial EffectModel Panel SettingsChip Settings CC SettingsSymptom Checks TroubleshootingApplicable signals SpecificationsDimensions WeightFCC Part 15 Statement Limited Warranty