Sony DVP-S725D operating instructions Specifications

Page 67

Specifications

CD/DVD player

Laser

Semiconductor laser

Signal format system

PAL /(NTSC)

Audio characteristics

Frequency response

DVD (PCM 96 kHz): 2 Hz to 44 kHz (±0.5 dB)*

DVD (PCM 48 kHz): 2 Hz to 22 kHz (±0.5 dB)

CD: 2 Hz to 20 kHz (±0.5 dB)

Signal-to-noise ratio

More than 110 dB (AUDIO OUT (1, 2) connectors only)

Harmonic distortion

Less than 0.0025%

Dynamic range

More than 100 dB (DVD)

More than 98 dB (CD)

Wow and flutter

Less than detected value (±0.001% W PEAK)

Outputs and inputs

	Jack	Output	Load impedance
	type	level

AUDIO OUT	Phono	2 Vrms	Over 10 kilohms
(1, 2)	jacks	(at 50 kilohms)

DIGITAL OUT	Optical	–18 dBm	Wave length: 660 nm
(OPTICAL)	output
	connector

DIGITAL OUT	Phono	0.5 Vp-p	75 ohms terminated
(COAXIAL)	jack

VIDEO OUT	Phono	1.0 Vp-p	75 ohms,
(1, 2)	jacks		sync negative

S VIDEO OUT	4-pin	Y: 1.0 Vp-p	75 ohms,
(1, 2)	mini DIN		sync negative
		C: 0.3 Vp-p	75 ohms terminated
		(PAL)
		0.286 Vp-p
		(NTSC)

COMPONENT	Phono	Y: 1.0 Vp-p	75 ohms,
VIDEO OUT	jacks		sync negative
(Y, CB/B-Y,		CB/B-Y,
CR/R-Y)		CB/B-Y,
		CR/R-Y:
		0.7 Vp-p	75 ohms

PHONES	Phone	12 mW	32 ohms
	jack

5.1 OUTPUT	Phono	2 Vrms	Over 10 kilohms
	jacks	(at 50 kilohms)

General

Power requirements

220 - 240V AC, 50/60 Hz

Power consumption

22 W

Dimensions (approx.)

430 × 98 × 305 mm (w/h/d) incl. projecting parts

Mass (approx.)

4.0 kg

Operating temperature

5 ˚C to 35 ˚C

Operating humidity

5% to 90%

Supplied accessories

	See page 7.

	* The signals from AUDIO OUT (1, 2) connectors and 5.1 ch L,R	Additional

	connectors are measured. When you play the PCM sound tracks
	with 96 kHz sampling frequency, the output signals from the
	DIGITAL OUT (OPTICAL, COAXIAL) are converted to 48 kHz
	(sampling frequency).	Information
	Design and specifications are subject to change without notice.	Information

67

Image 67

Contents CD/DVD Player Installing Precautions SafetyWelcome Table of Contents This Player Can Play the Following Discs About This ManualStructure Terms for discs TitleChapter TrackPrecautions Inserting batteries into the remote UnpackingGetting Started Required cords TV HookupsDirectly Setups for the playerTo connect the player to a wide-scr een TV To connect the player to a nor mal TVReceiver Amplifier Hookups DAT deck, etc When you play a DVD that is recorded in DTS formatWhen you play a DVD that is recorded in Mpeg format With a digitalSet each speaker position or distance, etc. See Speaker placementChannel Surround Hookups Amplifier with 5.1 ch inputsFront speaker Center speakerRear speaker R Select OSD using /., then pr ess /or Enter Select Français usingTo cancel using the setup display on the way Press SET UPPlaying Discs Operation You can turn on the player using the remoteU Power Playing DiscsPlaying at Various Speeds/Frame by Frame To change the playback speed Shuttle ModeTo play from the beginning of the disc Turn the click shuttleWhile playing a disc, press pto stop playback Press áPress ?//.//to select the title you want to play Using the Menu for EachUsing the title menu Press TitlePress ?//.//to select the item you want to change Using the DVD Menu Using the DVD menuPlaying Video CDs with PBC Functions PBC Playback Press DVD MenuDisplay information while playing the disc Using the Front Panel DisplayWhen playing back a DVD Going back to the menu screenWhen playing back a CD/VIDEO CD Using the Front Panel DisplayDisplay information while playing a disc Using Various Functions with the Control Menu Using Various Functions with the Control MenuUsing the Control Menu Display Control Menu Item List Control Menu Item List Searching for the Title/ Chapter/Track/Index/SceneChecking the Playing Time and Remaining Time To cancel selectingWhen playing a DVD PTIME/TEXT or TIME/MEMO When playing a Video CD during PBC playback pTIME/MEMOSelect C Selecting a Start Point Using the Time CodeTo cancel inputting Current chapter when playing a DVDDisc Memo Input display appears Checking the Information of the DiscLabeling discs Disc Memo Select Disc Memo Input / in TIME/TEXT or TIME/MEMOText or Disc Checking the Information of the DiscDisc label is stored To correct the charactersChanging the Sounds Z PAUDIO When playing a DVDDisplaying the audio information Disc Changing the Sounds Displaying the SubtitlesPSUBTITLE Angle is changed to the selected angle Changing the Angles ZSelectANGLE PressEffects of each item Setting for Digital Cinema Sound ZSide Rear Enhanced SurroundCreating the program Creating Your Own Program Program PlayTo cancel the programmed order PWhen playing a Video CD or CDPress áto star t Program Play To cancel Program Play To cancel programmingPlaying in Random Order Shuffle Play Using VariousWhen playing a DVD and when Program Play is set to OFF To cancel Shuffle PlayRepeating a Specific Portion A÷B Repeat Playing Repeatedly Repeat PlayStarting point point a is set A÷B Repeat setting display appearsTo cancel A÷B Repeat Play Select SET / in A-B Repea TChecking the Play Information Z PADVANCED When playing a DVDDisplays of each item Checking the Play Information Appears when the DVD has dual layersPDNR Adjustments for Playback Picture Video EQ Video Equalizer ZTo adjust the picture items You can adjust the following picture items individuallyVideo control display appears Adjustments for Playback Picture Video EQControl Select the pictur e item you want to adjust using Select Memor Y/ in Video EQDividing a Track into 9 Sections Strobe Play To cancel displaying multi-anglesTo cancel watching the strobe play Displaying Different Angles Simultaneously ZSetting the bookmark Setting and Selecting Favorite Scene BookmarkScanning the Title, Chapter and Track Z Press SET UP to display the setup display on the TV screen Using the Setup Display ZSettings and Adjustments Press SET UP on the remote Using the Setup DisplaySelect the item you want using /., then press / or Enter Select the setting you want using ?//.//, then press EnterDefault settings are underlined Setup Display Item ListPAUDIO Setting the Language for Display and SoundPOSD On-Screen Display PDVD MenuPBACKGROUND Settings for Display Screen Setup ZPTV Type PSCREEN SaverPAUTO Play Picture is stored in memoryPDIMMER Limiting Playback by Children Parental Control Custom Settings Custom Setup Standard Code number If you have forgot your passwordAUDIODRCDynamicRangeControl Settings for Sound Audio SetupAUDIOATTattenuation AudiofilterPDOLBY Digital Setting for the Signal to the Digital OutputPDOWNMIX PDIGITAL OUTPMPEG Settings for Sound Audio SetupPDTS PDISTANCE Speaker Set UpPSIZE Selects the size of the speakers to be connectedAdjusting the speaker volume Setting for Speakers Speaker SetupManufacturer Code Number AdjustmentsSwitch Number Buttons Controlling TVs with the remoteCode numbers of controllable receivers amplifiers SwitchControlling an AV receiver amplifier With the remote By pressing You canPower TroubleshootingPicture Sound TroubleshootingOperation Player starts playing the DVD automatically Player does not play from the beginning when playing a discSubtitles cannot be turned off when you play DVD Angles cannot be changed when you play a DVDFirst three characters Cause and/or Corrective Action Self-diagnosis functionSpecifications Glossary Video CD Code Language Language Code ListFront Panel Index to Parts and ControlsIndex to Parts and Controls Rear Panel Remote Index