LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
! WARNING |
| If you do not follow these instructions exactly, a fire or explosion |
| may result causing property damage, personal injury or loss of life. | |
|
|
|
A.This appliance is equipped with an intermittent ignition device which automatically lights the appliance. Do not try to light the pilot by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
FOR YOUR SAFETY “WHAT TO DO IF YOU SMELL GAS”
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
OPERATING INSTRUCTIONS
1. | STOP! Read the safety information above on this |
| information above. If you don’t smell gas, go to | |
| page. |
| the next step. | |
2. | Set the thermostat to lowest setting. | 8. | Push On/Off switch to “ON.” | |
3. | Turn off all electric power to the appliance. | 9. | Replace control access panel. | |
4. | This appliance is equipped with an ignition device | 10. | Turn on all electric power to the appliance. | |
| which automatically lights the burner. Do not try | 11. | Set thermostat to desired setting. | |
| to light the burner by hand. | 12. | If the appliance will not operate, follow the | |
5. | Remove control access panel. | |||
| instructions “To Turn Off Gas To Appliance” and | |||
6. | Push On/Off switch to "OFF." |
| call your service technician or gas supplier. | |
7. | Wait five (5) minutes to clear out any gas. If you |
|
| |
| then smell gas, STOP! Follow “B” in the safety |
|
|
TO TURN OFF GAS TO APPLIANCE
1. | Set the thermostat to lowest setting. | 3. | Remove control access panel. |
2. | Turn off all electric power to the appliance if service | 4. | Push On/Off switch to “OFF.” |
| is to be performed. | 5. | Replace control access panel. |
The Emerson logo is a trademark and service mark of Emerson Electric Co.