Preparation
Inserting batteries into the Remote Control
1Open the battery cover.
2Insert batteries (AA size) with the correct polarity as indicated by the + and - symbols inside the
battery compartment.
3Close the cover.
- | + |
+ | - |
CAUTION!
–Remove batteries if they are exhausted or not to be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed off properly and kept away from children.
Using the Remote Control
●Direct the remote control at the remote sensor of the player.
●Do not drop the remote control.
●Do not leave the remote control near extremely hot or humid places.
●Do not spill water or put anything wet on the remote control.
NTSC/PAL Conversion
DVD discs are recorded according to color system eg. NTSC and PAL. Your TV also operates according to a color system.
This DVD player is compatible with NTSC and PAL. To play on this DVD player, the color system of the DVD disc, the TV and the DVD player should match. If all three are not the same, the DVD may play in only black and white, the picture may roll continuously or the picture may appear distorted.
To activate the conversion, refer to page 11.
Switching On
1Connect the AC power cord to the power outlet.
2Switch on the TV and DVD player.
3Select the correct input channel at your TV and set the input source at your AV receiver to DVD. ➜ The player display lights up and the default screen appears on the TV.
4If you are using an external equipment (eg. audio system or receiver), turn them on and select the appropriate input source that was used to connect to the player output. Refer to the equipment owner’s manual for detail.
Note:
– If you do not have a proper picture or sound, refer to ‘Troubleshooting’ section.
8