Philips FW-C30/21 manual Maintenance, Troubleshooting, CD Player Operation, Radio Reception

Page 23

MAINTENANCE

Maintenance

Cleaning the Cabinet

Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives.

Cleaning Discs

• When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out.

Do not use solvents such as benzine,

thinner, commercially available cleaners, or antistatic spray intended for analog records.

Cleaning the CD lens

After prolonged use, dirt or dust may accumulate at the CD lens. To ensure good playback quality, clean the CD lens with Philips CD Lens Cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner.

Cleaning the Heads and the Tape Paths

To ensure good recording and playback quality, clean the heads, the capstan(s), and pressure roller(s) after every 50 hours of tape operation.

Use a cotton swab slightly moistened with cleaning fluid or alcohol.

You can also clean the heads by playing a cleaning tape once.

Demagnetizing the heads

Use a demagnetizing tape available at your dealer.

Warning! Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock.

If a fault occurs, check the points listed below before taking the system for repair.

Should any problems persist after you have made these checks, consult your nearest dealer or service center.

CD Player Operation

NO DISC” is displayed.

The disc is inserted upside down.

Place CD with printed side up.

Moisture condensation at the lens.

Wait until lens has adjusted to normal room temperature.

There is no disc in the CD tray.

Insert a CD.

The CD is dirty, badly scratched or

warped.

Clean or replace the CD.

The CD lens is dirty or dusty.

See section under Maintenance (page 23).

TROUBLESHOOTING

DISC NOT FINALIZED” is

English

displayed.

 

• The CD-RW or CD-R disc is not properly

 

recorded for use with a standard CD

 

player.

 

Read the instruction booklet of your CD- Rewritable or CD-Recorder on how to

finalize a recording.

The CD is badly scratched or dirty.

Replace or clean CD.

Radio Reception

Poor radio reception.

The signal is too weak.

Adjust the antenna.

Connect an external antenna for better reception.

The TV or VCR is too close to the stereo system.

Separate the stereo system from the TV or VCR.

Cannot tune to station

Wrong tuning grid.

Switch to the correct tuning grid.

23

pg 01-24/C30/21&/30-En

23

3/3/00, 4:23 PM

3139 116 19351

Image 23
Contents 3139 116 Mini Hi-Fi SystemsEs necesario que lea cuidadosamente su instructivo de manejo MéxicoEspañol Français English Class Laser ProductEnglish General Information General Information Safety InformationAccessories Supplied Safety InformationRear Connections PreparationConnecting other Equipment to your system Adjusting the Operating VoltageRemote Control FM Wire Antenna ConnectionDisc ControlsControls on the system and remote control Operating the System Sound Control DIM modeTo switch off DBB Mute only on remote controlPlaying a CD Discs for playbackLoading the CD Changer CD Direct PlayPlaying the program Selecting a desired trackProgramming Tracks Reviewing the programSelecting External Equipment Shuffle only on remote controlRepeat only on remote control AUXTuner Storing Preset StationsTuning to radio stations For MW Band To change from 9 kHz to 10 kHz or vice versa Tuning to Preset Radio StationsStation, the display will show Repeat steps 3Tape Playback Press Stopopen When playback is stoppedTape Loading a tape Rewind/Fast ForwardKeep the mic away from the speakers to prevent howling KaraokeStart singing or talking through the microphone Press Stopopen on tape deck 1 to stop recording One Touch RecordingCD Synchro Start Recording For recording, use only tape of IEC type I normal tapeRecording from other sources Clock SettingRecording ClockTo switch off the Timer Timer Sleep TimerTimer Setting Timer will not activate if a recording is in progressSpecifications SpecificationsCD Player Operation MaintenanceTroubleshooting MaintenanceGeneral Tape Deck Operation