Sylvania SRC2109D owner manual S2 8 9 8 a

Page 3

F IGURE A

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECT RICAL CODE

 

ANTENNA

 

LEAD I N

 

W I R E

 

GROUND

 

C L A M P

 

ANTENNA

 

DI SCHARGE UN I T

 

(NEC SECTION 810 -20)

ELECTRI C

 

SE RV I CE

 

EQU I PMEN T

 

 

GROUNDI NG CONDUCTORS

 

(NEC SECTION 810 -21)

 

GROUND CL AMPS

NEC - NATI ONAL ELECTRI CAL CODE

POWER SERVI C E GROUNDI NG

 

ELEC TR ODE SYSTEM

S2 8 9 8 A

(NEC ART 250, PART H)

13.Outdoor Antenna grounding-If an outside antenna or cable system is connected to the TV/VCR, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. (Fig. A)

14.Lightning-For added protection for this TV/VCR receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the TV/VCR due to lightning and power-line surges.

15.Power Lines-An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.Overloading-Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

17.Object and Liquid Entry-Never push objects of any kind into this TV/VCR through openings as they may touch dan- gerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the TV/VCR.

18.Servicing-Do not attempt to service this TV/VCR yourself as opening or removing covers may expose you to danger- ous voltage or other hazards. Refer all servicing to quali- fied service personnel.

19.Damage Requiring Service-Unplug this TV/VCR from the wall outlet and refer servicing to qualified service per- sonnel under the following conditions:

a.When the power-supply cord or plug is damaged or

frayed.

b.If liquid has been spilled, or objects have fallen into the TV/VCR.

c.If the TV/VCR has been exposed to rain or water.

d.If the TV/VCR does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV/VCR to its nor- mal operation.

e.If the TV/VCR has been dropped or damaged in any

way.

f.When the TV/VCR exhibits a distinct change in perfor- mance-this indicates a need for service.

20.Replacement Parts-When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer that have the same character- istics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other haz- ards.

21.Safety Check-Upon completion of any service or repairs to this TV/VCR, ask the service technician to perform routine safety checks to determine that the TV/VCR is in proper operating condition.

22.Heat-This TV/VCR product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

- 3 -

EN

9J27

Image 3
Contents SRC2109D Important Safeguards S2 8 9 8 a Important Copyright Information PrecautionsLocation Avoid the Hazards Electrical Shock and FireTable of Contents Supplied Accessories FeaturesOperating Controls and Functions Remote ControlRear View VHF/UHF Separate Antennas Preparation for USEVHF/UHF Combined Antenna Dipole Antenna Hook UPCable with CONVERTER/ Descrambler BOX or Satellite BOX Installing the BatteriesExternal Input Mode Mobile ConnectionAuto Clock Setting SET UP for USEChannel SET UP for First Time Clock SET UP Auto / ManualIf you choose Auto Manual Clock SettingPlease Note Channel SET UP AgainTo Change Clock Setting Deleting or Adding ChannelTo Cancel the DAYLIGHT-SAVING Time DAYLIGHT-SAVING TimeSelecting the Language Picture Control Game ModeTV Operation Watching a TV ProgramPlayback Auto Repeat PlaybackNormal Playback Zero Return SearchStill Picture Picture SearchVertical Hold Control Tracking AdjustmentRecording Rental PlaybackSkipping Unwanted Scenes During Recording Normal RecordingPushes Display Recording length Timer RecordingTo set another program, repeat steps 2 to To Correct a ProgramHints for Automatic Timer Recording Wake UP TimerAuto Return Copying a Video Tape Sleep TimerTo Cancel the Wake UP Timer To Cancel the Sleep TimerReal Time Tape Counter Special FeaturesMaintenance On Screen DisplayProblem Corrective Action Troubleshooting GuideOther Specifications SpecificationsGeneral Specifications Electrical SpecificationsControles DE Operación Y SUS Funciones IndicePanel Trasero Conexiones DE ANTENA/CABLE Instalación DE LAS Pilas Preparación DE Canales POR Primera VEZ Get it fixed, at your home or ours