
TV OPERATION
WATCHING A TV PROGRAM
TV/VCR
1Turn on the TV/VCR/DVD
Press the POWER button to turn on the TV/VCR/DVD.
2Select the channel number
Press the CHANNEL button K or L to select your desired channel number or press the number on the remote control.
Note for using the Number button on the remote control:
¡You must precede
¡When selecting cable channels which are higher than 99, press +100 first, then press the last two digits. (Example: to select channel 125, first press “+100” then press “2” and “5”).
Remember: If the TV/VCR/DVD is connected to a cable box or satellite box, the TV/VCR/DVD must be on CH3 or CH4, then the channel to be viewed must be selected on the cable box or satellite box.
3Adjust sound
Press the VOLUME button X or Y to adjust the volume.
VOLUME 20
C C C C C C C C C C C C
NOTES:
•If you press the CHANNEL button K or L in the DVD mode, you can change the TV channels.
Even if you turn off the TV/VCR/DVD in the DVD mode, when you turn it on again, it will go into the TV/VCR mode.
DEGAUSSING
TV/VCR
This television has a degaussing circuit that will clear up color errors on the TV screen that are caused by any excess magnetism which happens to get too close to the TV. This circuit is designed to operate once when the set is first plugged in. If minor color errors are seen in some locations on the screen, please unplug the TV for approximately 15 minutes. When the TV is plugged back in, the degaussing cir- cuit will operate once to clear them up. Repeat this procedure any time the TV screen is accidentally magnetized, or when the TV is moved or relocated.
PICTURE CONTROL
TV/VCR
The TV/VCR/DVD’s picture controls – BRIGHT, CONTRAST, COLOR, TINT and SHARPNESS – are preset to factory specifications. Although they are usually the best, you may need to make some further adjustments to your preference.
NOTES:
•Procedures must be followed within 5 seconds or the Picture Control mode will be cancelled.
•When setting the Picture Control, the Game mode will be cancelled.
Make sure ...
•TV/VCR/DVD power must be turned on.
1Select “PICTURE CONTROL”
Press the PICTURE button on the remote control.
2Select item you want to adjust
Press the Arrow button K or L until desired control is displayed.
BRIGHT |
|
CONTRAST |
|
COLOR |
|
TINT | BRIGHT |
| – P P P P P P P C P P P P P P P + |
SHARPNESS |
|
3Adjust the picture control
Press the Arrow button s or B to adjust to your desired level.
| Arrow Button { | Arrow Button B | |
|
|
| |
BRIGHT | to decrease | to increase | |
brightness | brightness | ||
| |||
|
|
| |
CONTRAST | to decrease | to increase | |
contrast | contrast | ||
| |||
|
|
| |
COLOR | to pale | to brilliant | |
|
|
| |
TINT | to purple | to green | |
|
|
| |
SHAPNESS | to soft | to clear | |
|
|
|
•If there is a power failure of any kind, the TV/VCR/DVD will retain its memory for this fea- ture.
- 19 - | EN |
1C29