Emerson EWC0902 owner manual Installing the Batteries, External Input Mode, Mobile Connection

Page 10

CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown in drawing.

By using this connection you can also record scram- bled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/VCR Remote Control. Unattended timer record- ing is limited to one channel at a time.

TO RECORD A SCRAMBLED/UNSCRAMBLED CHANNEL

1.Set the TV/VCR channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to record from your Cable Converter Box or Satellite Box.

INSTALLING THE BATTERIES

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 “AA” penlight batteries into the battery compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the cover.

EXTERNAL INPUT MODE

When using an external input signal (another VCR or video camera), connect the player’s audio/video out- put cables to the AUDIO IN/ VIDEO IN jacks of your TV/VCR. Then press the CHANNEL K or L button until “AUX” appears on the screen.

AUX

MOBILE CONNECTION

WARNING: The driver should never watch the TV/VCR while operating a motor vehicle.

CAUTION: If you use the TV/VCR with the vehicle’s engine off, recharge the vehicle’s battery after about every 4 hours of use to prevent it from running down. After you fin- ish using the TV/VCR be sure you unplug the car-battery cord from the cigarette-lighter socket.

1)The supplied indoor antenna is adequate when your vehicle is stationary. For best reception on the road, use a high-quality VHF/UHF mobile TV antenna.

2)Attach the car battery cord to the DC13.2V(12V) connector on the back of the TV/VCR. Then, con- nect the other end to your vehicle’s cigarette- lighter socket.

NOTES:

Be sure your vehicle has a 13.2-volt (12-volt), neg- ative-ground electrical system.

Be sure you use only the supplied car battery cord. Using another cord could damage the TV/VCR.

Be sure the socket is free of ashes and other debris.

Be sure to push the car battery cord’s plug com- pletely into the cigarette-lighter socket.

Always unplug the car battery from the cigarette- lighter socket before you unplug it from the TV/VCR.

You must disconnect the car battery cord from the TV/VCR before you can use the AC power.

Be sure to replace the fuse with only the same type, 5A, 250V.

 

To the vehicle's

 

cigarette-lighter socket

 

VHF/UHF Combination

 

Mobile Antenna

 

(Not supplied)

 

Car battery cord

 

(Supplied)

ANT.

DC13.2V

 

- 10 -

EN

9J27

Image 10
Contents EWC0902 Important Safeguards S2 8 9 8 a Avoid the Hazards Electrical Shock and Fire PrecautionsLocation Important Copyright InformationTable of Contents IndiceFeatures Supplied AccessoriesRemote Control Operating Controls and FunctionsRear View Dipole Antenna Hook UP Preparation for USEVHF/UHF Combined Antenna VHF/UHF Separate AntennasMobile Connection Installing the BatteriesExternal Input Mode Cable with CONVERTER/ Descrambler BOX or Satellite BOXClock SET UP Auto / Manual SET UP for USEChannel SET UP for First Time Auto Clock SettingManual Clock Setting Deleting or Adding Channel Channel SET UP AgainTo Change Clock Setting Please NoteDAYLIGHT-SAVING Time To Cancel the DAYLIGHT-SAVING TimeSelecting the Language Watching a TV Program Game ModeTV Operation Picture ControlAuto Repeat Playback PlaybackNormal Playback Picture Search SearchStill Picture Zero ReturnRecording Tracking AdjustmentTo Cancel the Rental Mode Vertical Hold ControlNormal Recording Skipping Unwanted Scenes During RecordingChannel CH61 Tape Speed SP Timer RecordingManual Clock SET To Correct a Program To set another program, repeat steps 2 toWake UP Timer Hints for Automatic Timer RecordingAuto Return To Cancel the Sleep Timer Sleep TimerTo Cancel the Wake UP Timer Copying a Video TapeOn Screen Display Special FeaturesMaintenance Real Time Tape CounterProblem Corrective Action Troubleshooting GuideTV/VCR Electrical Specifications SpecificationsGeneral Specifications Other SpecificationsControles DE Operación Y SUS Funciones Panel Trasero Conexiones DE ANTENA/CABLE Instalación DE LAS Pilas Preparación DE Canales POR Primera VEZ Funai Corporation Please do not Ship Your Unit to the Teterboro Address