SET UP for USE, Channel SET UP for First Time

SET UP FOR USE

You can program the tuner to scan all the channels you receive in your area.

NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR channel selector to the output channel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box.

CHANNEL SET UP FOR THE

FIRST TIME

1Plug in the TV/VCR power cord

Attach the smaller end of the sup-

plied AC cord to the AC 120V
connector on the back of the
TV/VCR. Then, plug the other	AC 120V
end into a standard AC outlet.

NOTES:

•You must disconnect the car battery cord from the TV/VCR before you use AC power.

•If some digits appear in the corner of the screen, press the POWER button without unplugging the power cord.

2Turn on the TV/VCR

Press the POWER button to turn on the TV/VCR.

3Select “ENGLISH” or “ESPAÑOL”

	Select “ENGLISH” or	– SET UP –
	“ESPAÑOL”=Spanish using the	B LANGUAGE
	F.FWD/B or REW/s button. “[ ]”	[ENGLISH] ESPAÑOL
	F.FWD/B or REW/s button. “[ ]”	AUTO PRESET
	indicate the selected language.	AUTO PRESET
	indicate the selected language.

TO SELECT A DESIRED CHANNEL

You can select the desires channel by using the CHANNEL K or L button on or directly pressing the number buttons on the remote control.

Note for using the number buttons:

•When selecting cable channels which are higher than 99, press the +100 button first, then, press the last two digits. (Example: to select channel 125, first press the +100 button then press “2” and “5”).

•You must proceed single-digit channel numbers with a zero (Example: 02 ... 09).

CLOCK SET UP

(AUTO / MANUAL)

Set the clock accurately for proper automatic timer recording. If the Public Broadcasting Station (PBS) is available in your area, follow “AUTO CLOCK SETTING”. If it is not, follow “MANUAL CLOCK SETTING”.

AUTO CLOCK SETTING

You can have the TV/VCR set the clock automatical- ly by using the Public Broadcasting Station (PBS) channel in your area. Once you have set the clock by

4Begin auto preset

Press the PLAY/K or STOP/L but- ton to point to “AUTO PRESET”. Then press the F.FWD/B button. The tuner scans and memorizes all active channels in your area.

NOTES:

– SET UP –

LANGUAGE [ENGLISH] ESPAÑOL

BAUTO PRESET

using the following procedure, the TV/VCR will automatically monitor the correct time and date being broadcast by the PBS station in your area, using a new service called Extended Data Service (XDS).

Make sure ...

• TV/VCR power must be turned on.

•The TV/VCR distinguishes between standard TV channels and cable channels.

•If you want to play or record a video tape BEFORE presetting the tuner, you must press the MENU but- ton on the remote control. To preset the tuner again, see “CHANNEL SET UP AGAIN” on page 13.

•The TV/VCR may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto preset again in the fine receiving conditions.

5After scanning

The tuner stops on the lowest memorized channel. If you want to recall the selected channels, you can select the desired channel directly with the remote control number buttons or CHANNEL K or L button.

• Confirm that the antenna connections are correct.

• The cable converter box must be turned on if your

TV/VCR is connected directly to it. (See NOTES:)

• The channel is properly set in advance.

- 11 -

Emerson EWC0902 SET UP for USE, Channel SET UP for First Time, Clock SET UP Auto / Manual