Emerson EWC1303A owner manual Normal Recording, Skipping Unwanted Scenes During Recording

You can ONLY watch the same TV program that is being recorded.

1Select the channel to be recorded

Kor L button.

Remember: If the TV/VCR is con- nected to a cable box or satellite box, the TV/VCR must be on CH3

or CH4, then the channel to be recorded must be selected on the cable box or satellite box.

2Select the tape speed

Press the SPEED button to select the desired tape speed (SP/ SLP).

SP

Press the RECORD button.

SP

4Stop recording

Press the STOP button when recording is completed.

SKIPPING UNWANTED

SCENES DURING RECORDING

Press the PAUSE/STILL button to PAUSE temporarily stop recording.

Press the PAUSE/STILL or RECORD button to resume record-

ing.SP

NOTES:

•After five minutes, the TV/VCR will automatically switch to the Recording mode to prevent tape dam- age.

•If “CLOSED CAPTION (ON)” is selected, the On- Screen Display will appear for 5 seconds, then dis- appear.

This function enables you to set a recording length simply by pressing the REC/OTR button on the TV/VCR.

Make sure ...

•TV/VCR power must be turned on.

•Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)

NOTES:

•This function CANNOT be done from the remote control.

•Recording starts immediately when the REC/OTR button is pressed.

•When the REC/OTR button is pressed 18 times, the TV/VCR returns to the Normal Recording mode.

•To stop the OTR operation, press the STOP button on the TV/VCR or on the remote control.

•To show the remaining time, press the DISPLAY button on the remote control so that “OTR” appears on the TV screen. (It will show up momen- tarily then disappear.)

•Recording stops when 0:00 is reached.

•Please note that in the SLP mode maximum record- ing time, assuming the tape is started at the begin- ning, is 8 hours using T-160 (or 6 hours using T-120).

•If the tape runs out before the end time, the TV/VCR will switch to the Stop mode immediate- ly, ejects the tape and turns itself off.

•If you press the power button during OTR, the TV/VCR continues recording until the selected length is reached.

1Select the channel to be recorded

Press the number buttons on the remote control or the CHANNEL K or L button.

Remember: If the TV/VCR is connected to a cable box or satellite box, the TV/VCR must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box.

2Select the tape speed

Press the SPEED button to select the desired tape speed (SP/ SLP).