Magnavox MC09D1MG Mobile Connections, Fuse Replacement, Car battery cord, To Cigarette Lighter

Page 7

MC09D1MG 3/22/02 1:15 PM Page 7

Hooking Up the TV/VCR (cont’d) 7

Mobile Connections

Usually, the supplied rod antenna provides adequate reception. But when you want to watch TV outdoors or in a vehicle, try a mobile antenna (not supplied) or an indoor dipole antenna (not supplied) for better reception.

1

Connect an antenna to the ANT(enna) jack. If you do not use the supplied rod antenna, refer to the instructions with your other antenna to make a connection.

Rod Antenna

(supplied)

ANT

2

Make sure your vehicle has a 13.2-volt, negative ground electrical system. Connect one end of the car battery cord to the DC 13.2V jack on the back of the TV/VCR. Then connect the other end of the car battery cord to the

DC 13.2V

cigarette lighter in your vehicle.

Use only the supplied car battery cord. Using another cord could damage the TV/VCR. Make sure you push the car battery cord’s plug completely into the cigarette lighter.

car battery cord

Fuse Replacement

If the TV/VCR does not have power when connected properly in your vehicle, replace the fuse in the car battery cord.

Use only a 5-amp, 250-volt, fast blow fuse, which is available at an electronics retailer.

1

To remove the old fuse, unscrew the red cap from the end of the cord. Place your fingers on the grooved part of the cap and turn the cap counter-clockwise.

2

When the cap is removed, the red cap and the silver tip will be loose. The fuse will be loose inside the end of the cord.

3

Remove the old fuse and insert a new fuse.

4

Replace the red cap and the silver tip. The fuse will tighten into place as you screw on the cap, turning the cap clockwise. (The end of the fuse will fit into the silver tip, which is in the center of the red cap when tightened.)

To Cigarette

Lighter

Helpful Hints

•Do not watch TV while driving.

•Make sure the cigarette lighter jack is free of ashes and other debris.

•Always unplug the car battery cord from the cigarette lighter before you unplug it from the TV/VCR.

•You must disconnect the car battery cord from the TV/VCR before you can use standard electrical (AC) power.

•If you use the TV/VCR with the vehi- cle’s engine off, recharge the vehicle’s battery often. Unplug the car battery cord from the cigarette lighter when you finish using the TV/VCR.

•When you use the TV/VCR with a car battery cord, noise may appear on the TV/VCR screen.

•Do not use this TV/VCR in high tem- perature conditions. Details are on page 41.

Page 6 Page 8
Image 7
Page 6 Page 8
Contents MC09D1MG For Customer Use Dear Magnavox product ownerDeclaration of Conformity FeaturesSafety Precautions IntroductionTable of Contents TV/VCR Maintenance Putting Batteries in the Remote ControlBattery Safety Using the Remote ControlHooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownBefore you turn on the TV/VCR, go to page eight To Cigarette Lighter Fuse ReplacementCar battery cord Mobile ConnectionsSetting TV Channels for the First Time Remove the menu Press MENU. Press PLAY/ or STOP/ to select LanguageResetting TV Channels With CHannel Adding/Deleting ChannelsChannels are set. Details are on pages eight Setting the ClockAuto Clock Setting Before you begin, make sureSetting the Clock cont’d Manual Clock Setting Setting the Clock cont’dManual Clock SET Month DAY Daylight-Savings Time Setting Clock Auto Clock Auto Clock CH Manual Clock SETREW/ rewind Button Power ButtonReset Button PLAY/ ButtonFront Panel AC 120V Jack Rear PanelANTenna Jack DC 13.2V JackOn-Screen Status Displays Power fails Press F.FWD/B or REW/s to adjust the con- trolInsert a tape in the TV/VCR PlayingViewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPTape Speeds RecordingRecording options are on pages To stop an OTR, press STOP/p Recording stops when 000 is reachedOne-Touch Recording Display Recording length PressesFor a one-time recording, press PLAY/ until Timer RecordingTion. Then, press F.FWD/B Number appears. Example CH61 Then pressMinute appears. Example 850PM Press Press PLAY/ or STOP/ until the desired endHour appears. Example 830PM Then, press FWD/BCancelling Timer Recordings Timer Recording cont’dExtending a Timer Recording Correcting a Timer RecordingSelect USER’S SET UP. Then, press F.FWD/ B Timer Recording Auto ReturnPress MENU. Press PLAY/ or STOP/ to Rerecording Tape Duplication ALL or Blank appears Repeat PlayPress PLAY/ or STOP/ to select Repeat Press F.FWD/B or REW/s repeatedly untilRental Playback To Cancel Rental PlaybackZero Return Insert a tape Press Time Search Time SearchThis function will not operate dur Ing recording Press SLEEP/WAKE UP until Sleep Timer Sleep TimerPress Menu to exit the Sleep Timer setting Press F.FWD/B or REW/s to select TV or Wake Up TimerBefore you begin Press PLAY/ or STOP/ to select TV/TAPEAutomatic Operation Features Helpful Hints Helpful Hints cont’d Glossary Specifications Renewed Index Supplied Accessories
Top Page Image Contents