Magnavox CCB193AT owner manual Timer Recording cont’d

Page 33

Timer Recording (cont’d) 33

4

Use the Number buttons (1-8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not been stored yet).

NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen for a few seconds. Then information about the program in that position will appear on the screen. If this happens, press the STATUS/EXIT but- ton. Then use the Number buttons to select another position.

5

Use the Number buttons to enter the channel of the TV program you want to record.

●If you are recording from line input, press 0, 0. A/V IN will appear on the screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 34.

4-7

POWERSLEEP/WAKE UP

	PLAY
REW		F.FWD
	STOP
MENU	STATUS/EXIT	CLEAR

1	2	3
4	5	6	CH.
4	5	6
7	8	9
SLOW	0	SURF	VOL.
SLOW	0	SURF
SPEED	MEMORY	PAUSE/STILL
REC/OTR	TRACKING		MUTE

Helpful Hints

•If the numbers entered do not match the TV/VCR’s clock or calen- dar, the entry will be rejected and a question mark will appear on the screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the information you want to change is flashing. Then enter the correct

information.

Image 33

Contents CCB193AT For Customer Use Dear Philips product ownerSafety Precautions FeaturesIntroduction Declaration of ConformityTable of Contents Using the Remote Control Putting Batteries in the Remote ControlTV/VCR Maintenance Recording PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Crooked Pin Straight Pin Hooking Up the TV/VCR cont’dTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Menu button Language SelectionAutomatic Channel Setup Press the PLAY/ o button or the STOP/ p button to select Adding/Deleting ChannelsSetting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Wait for the TV/VCR to find Manual PBS Channel Selection Select SET PBS CH. MANUAL. Then, press the F.FWD/B Press the PLAY/ button or the STOP/ button toButton Use the Number buttons to select your PBS stationDaylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons REWind/ Button STOP/ ButtonSTATUS/EXIT Button Menu ButtonAdjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFReminder Press the PLAY/ button or the STOP/ button to selectVHS Quasi Play Back Sqpb PlayingTo stop recording, press the STOP/ button Tape Speeds RecordingOTR One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationDaily Timer RecordingTimer Recording cont’d Timer Recording cont’d With the TV/VCR on, press the Menu button Checking or Clearing Timer RecordingsDefeat Recording Repeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the STATUS/EXIT button to remove the menu. A-B Repeat Play cont’dPress the STATUS/EXIT button. The real-time counter will Real-Time Counter MemoryForward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureSmartLock Enter Your Access CodeExample Specific Sub-ratings SmartLock cont’dTo change the access code, follow these steps Rating Explanations Ground Blue BackgroundPress the SLEEP/WAKE UP button Sleep TimerTimer Sleep Wake UP TV on ON-TIME Wake Up TimerVolume Bar Example Closed CaptionMenu ScreenStandard Closed Captions Closed Caption cont’dAutomatic Operation Features Specifications Helpful Hints Helpful Hints cont’d Glossary TV/VCR Combination Limited WarrantyIndex Deleting Reviewing SetupPage Supplied Accessories