Memorex MVT2137 Ventilation, Power Sources, Grounding or Polarization, POWER-CORD Protection

Page 3

IMPORTANT SAFEGUARDS

9.VENTILATION

Slots and openings in the cabinet back or bottom are provided for ventilation, and to ensure reliable operation of the unit, and to protect it from overheat- ing. These openings must not be blocked or covered. The openings should never be blocked by placing the unit on a bed, sofa, rug, or other similar surface. This unit should never be placed near or over a radiator or heat source. This unit should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.

10.POWER SOURCES

This unit should be operated only from the type of power source indicated on the rating plate. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For units intended to operate from battery power, or other sources, refer to the operating instructions.

11.GROUNDING OR POLARIZATION

This unit is equipped with a polarized alternating- current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug, if your unit is equipped with a 3-wire grounding-type plug, a plug having a third (ground- ing) pin. This plug will only fit into a grounding-type power outlet. This too, is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet.

Do not defeat the safety purpose of the grounding- type plug.

12.POWER-CORD PROTECTION

Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

13.LIGHTNING

To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges.

14.POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

15.OVERLOADING

Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to proper ground- ing of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

18.SERVICING

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

ENGLISH

3

5A3A901A E P02-11

3

3/18/02, 10:06 PM

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Atencion TV/CATV Mode Selection Seleccion DE Modo DE TV/CATVRetain Instructions CleaningAccessories Read InstructionsVentilation Power SourcesPOWER-CORD Protection Power LinesHeat Damage Requiring ServiceReplacement Parts Safety Check Wall or Ceiling MountingLocation and Handle Safety PrecautionsMoisture Condensation Install the TV/VCR in Your CAR When YOU Experience the Above CONDI- TionsFeatures Driving SafetyImportant Notes Table of Contents Cassette Loading Slot To insert or remove a video tape Location of ControlsFront Rear Description of ControlsEject Button Press to eject the tape Remote ControlEffective Distance of the Remote Control Remote Control Power SourcesBattery Installation Battery PrecautionsReplacing the Fuse in the CAR Cord Plug Antenna ConnectionsCable TV Connections Setting the LanguageFor Subscribers to Basic Cable TV Service For Subscribers to Scrambled Cable TV ServiceAuto Clock Setting VHF/UHF/CATV Channels Manual Clock SettingTV mode direct channel selection Catv mode direct channel selectionTV Operation Automatic Memory Tuning TV Operation To Memorize ChannelsTV/CATV Selection To Memorize Channels Setting the V-CHIP To ADD/DELETE ChannelsTo SET the V-CHIP Menu screen is cleared To SET the on TimerTo Change Password Display onPicture Control Adjustments To SET the OFF TimerPlayback Special Playback Timer Recording ONE-TOUCH Timer Recording OTRUsing Zero Return Using the Real Time Tape CounterDuplicating a Video Tape Connection to Another VCRConnection to Camcorder Reception Disturbances Video Head CleaningTV Broadcast Reception Troubleshooting GuideSymptom Cause Possible Solution Power Operate Heads Two or three hours until it goes offPlayback Symptom Cause Possible SolutionRemote Control RecordingVCR SpecificationsAccessories TelevisionMemo
Top Page Image Contents