Concrete Walls, Install anchors | Vizio VMT40-55M instruction

VIZIO VMT40-55M User Manual

Concrete Walls

Mark and drill holes

1.Tape the included poster to the wall. Hold the wall plate [1] up to the poster and use the built-in level to make sure it is level. Put the wall plate [1] aside.

2.Drill 6 holes with a 1/2” masonry bit, 2-1/2” deep where indicated. Remove the poster.

Install anchors

1. Install the provided anchors [11] in the holes, flush with the wall so that the hinged end faces out.

Anchor mount to wall

3.Using a 7/16” wrench, attach the wall plate [1] to the wall with the supplied lag bolts and washers [9] & [10].

4.Use the level before tightening bolts.

Note: Do not over-tighten lag bolts. Tighten only until they are firmly against the wall plate.