Backplate Installation - Concrete Surface
NOTE: These installation instructions will apply to the
1.Determine where the mount location will be.
2.After this has been determined,
NOTE: Be sure that the end of the back plate that has a lip is pointing as shown in (Figure 3).
3.Once the mounting holes are marked on the wall, use a 5/16” drill bit and drill 4 holes into the concrete surface (Figure 3).
4.Once the holes have been drilled, gently tap the anchor studs into each hole, until the washer is flush (even) with the concrete surface.
5.Place the backplate onto the concrete surface and slowly tighten each nut onto its respective anchor stud (Figure 4).
Lip | Lip |
Figure 3. Backplate - Concrete Surface | Figure 4. Backplate Installation - Concrete |
| Surface |
Page 6 | Installation Instructions |