(2) M4 x 10mm Phillips screws
Display | (2) M4 x 10 |
| Phillips screws |
Figure 6. Monitor Installation
Installing the Monitor
1.Loosely tighten two (2) M4 x 10mm Phillips Head screws to the top of the mounting points.
2. Insert the head of the screws through the keyhole slots and then secure the bottom two (2) M4 x 10mm Phillips Head screws to secure the flat panel to the mounts, then tighten the upper M4 x 10mm Phillips Head screws (Figure 6).
CAUTION: Do not over tighten the M4 x 10mm Phillips Head screws, or else damage to the display may occur.
Cable Access
Please refer to Figure 7 for the correct way to route existing any cables.
Articulating Swingout Arm
Cable access holes
Cable access plastic covers
Figure 7. Cable Routing
Page 8 | Installation Instructions |