SoundCraft Rac Pac manual Stereo Public Address

Page 19

Stereo Public Address

In this basic PA set-up, various sources are connected to the inputs, microphones to Mic inputs and keyboards etc. to Line inputs. Note that some guitars will not produce sufficient level for a direct connection, and will require a Direct Injection (DI) box connected via the microphone input. The mic channel has a compressor/limiter included in the insert point and a feed to a reverb unit from the direct output. The reverb output is brought back to the mix on FX Return 1. The output is taken from Mix L & R and connected to the speakers via a suitable power amplifier. A compressor/limiter (or graphic equaliser if required) is included in the Mix Inserts, and a cassette machine connects to the 2TK Return to provide interval music. The Groups may be used to combine several inputs under the control of a single fader before mixing to the L & R outputs.

R

SPIRIT FOLIO RAC PAC

18

 

Image 19
Contents MIX Introduction Safety PrecautionsConnectORS ConNections Input Channels Connections Master Section Initial Setting UP Stereo Recording to DAT Setting UP for RecordingTrack Recording Mono Input Channels Trim Controls in DetailAUX Sends EqualiserSolo PANRouting FaderEqualisation Stereo Input CHANNELsBalance PFL Stereo ReturnsLevel Auxiliary SendsMIX 2TK to MIX Groups to MIXMIX Fader Track 2TK Return LevelSpirit Folio RAC PAC AUX AFL Solo ModePhantom Power Auxiliary MastersMultitrack Recording ApplicationsStereo Public Address Relocating the connector panel Technical Specification AFL After Fade Listen GloSSARYSystem Block Diagram