Vizio E321MV Television Antenna Connection Protection, DTV Transition Advisory, Power Lines

Page 6

Television Antenna Connection Protection

If an outside antenna/satellite dish or cable system is to be connected to the TV, make sure that the antenna or cable system is electrically grounded to provide some protection against voltage surges and static charges.

Article 810 of the National Electrical Code, ANSI/NFPSA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of the grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements of the grounding electrode.

Lightning Protection

For added protection of the TV during a lightning storm or when it is left unattended or unused for long periods of time, unplug the TV from the wall outlet and disconnect the antenna or cable system.

Power Lines

Do not locate the antenna near overhead light or power circuits, or where it could fall into such power lines or circuits. Remember, the screen of the coaxial cable is intended to be connected to earth in the building installation.

E321MV

DTV Transition Advisory

The nationwide switch to digital television broadcasting was complete on June 12, 2009. Analog-only television sets that receive TV programming through an antenna now need a converter box to continue to receive over-the-air TV. Watch your local stations to find out when they will turn off their analog signal and switch to digital-only broadcasting. Analog-only TVs should continue to work as before to receive low power, Class A or translator television stations and with cable and satellite TV services, gaming consoles, VCRs, DVD players, and similar products.

For additional information, please contact the parties listed below, as appropriate:

FCC (US Federal Communications Commission)

Web: www.fcc.gov

Phone: 1-888-CALL-FCC (1-888-225-5322)

TTY: 1-888-TELL-FCC (1-888-835-5322)

Fax: 1-866-418-0232

E-mail: fccinfo@fcc.gov

NTIA (National Telecommunications and Information Administration)

Web: www.ntia.doc.gov

Phone: 1-888-DTV-2009 (1-888-388-2009)

Ground Clamp

Electric Service Equipment

Antenna Lead In Wire

Antenna Discharge Unit

(NEC Section 810-20)

Grounding Conductors

(NEC Section 810-21)

Ground Clamps

Power Service Grounding Electrode System (NEC ART 250, part H)

List of US Television Stations: www.high-techproductions.com/usTVstations.htm

Your TV comes with a built-in tuner capable of processing digital broadcasts. No extra converter box is needed.

Image 6
Contents Class Razor LED LCD Hdtv To qualify for Energy Star rating Thank You for Choosing Vizio When Reading this ManualWelcome My Product InformationImportant Safety Instructions E321MV DTV Transition Advisory Power LinesTelevision Antenna Connection Protection Lightning ProtectionTable of Contents Troubleshooting & Technical Support Installing the TV Inspecting the Package ContentsInstalling the TV Installing the TV on a Wall E321MV Controls and Connections Rear PanelRight Side Panel Front PanelRemote Control Replacing the Batteries Connecting Your Devices Before You BeginBest Hdmi Completing the First-Time Setup First-time setup is completeAdjusting the TV Settings Navigating the On-Screen MenuChanging the Input Source Setting Up Channels Customizing Input NamesChanging the Signal Source Scanning for ChannelsScanning for New or Additional Channels Removing Channels from the Master ListChanging the Audio Language Customizing Channel NamesSetting the TV’s Date and Time Setting the Time ZoneChanging the On-Screen Menu Language Setting the Date and Time Adjusting the Time for Daylight SavingsEnabling or Disabling Automatic Date and Time Updates Current TimeAdjusting the TV Settings for Use with a PC Turning the Vizio Light On or OffUsing the Other Menu Settings Setting the Sleep TimerUsing the Photo Menu Viewing a USB Photo SlideshowView Slideshow Start a full-screen photo slideshow Setting the Screen Aspect Ratio Using the Modify Photo MenuScreen Aspect Ratio Table Adjusting the Equalizer Settings Adjusting the Audio SettingsEnabling or Disabling SRS TruVolume Enabling or Disabling SRS TruSurround HDAdjusting the Speaker Balance Selecting the Digital Output ModeEnabling or Disabling the Built-In Speakers Resetting the Audio Settngs Adjusting the Picture SettingsAdjusting Bass and Treble Levels Enabling or Disabling the Ambient Light SensorChanging the Picture Mode Adjusting the Noise Reduction SettingAdjusting the Color Temperature Enabling or Disabling Color EnhancementEnabling or Disabling Adaptive Luma Accessing the Parental Controls Menu Using the Parental ControlsResetting the Picture Settings Enabling or Disabling DCR Dynamic Contrast RatioBlocking and Unblocking Content by Rating Locking and Unlocking ChannelsSetting the TV Button Locks Resetting the Content LocksChanging the Parental Control Passcode Restarting the Setup Wizard Viewing System Info and Resetting to Factory DefaultsRestoring the TV to the Factory Default Settingss Displaying System InformationSetting Up Closed Captioning Changing the Appearance of Digital Closed CaptionsWindow Opacity Change the edge type Troubleshooting & Technical Support Picture is distorted When I change input source, the volume changesWhen I change input source, the display image changes size Display image does not cover the entire screenSpecifications Limited Warranty FCC warning Legal & ComplianceFCC Class B Radio Interference Statement Canada CSA Germany VDEPage