VIZIO XVT472SV User Manual
Audio Troubleshooting
Issue |
| Solution |
|
| ∙ Press Volume + (Up) on the remote control or side of your HDTV. |
|
| ∙ Press MUTE on the remote control to make sure that MUTE is not ON. |
|
| ∙ Check the MTS Audio settings in the Tuner menu to insure they are set to |
No audio |
| Stereo/English. ( TV input only ) |
|
| ∙ Verify that your HDTV Speakers are On in the Audio menu. |
|
| ∙ Check the video/device cable integrity. Try another cable (HDMI, Component, |
|
| AV/Composite, Coax etc.) |
|
| ∙ Change audio settings of the external device. |
|
| ∙ If you are using an antenna, the signal strength of the channel may be low. |
|
| Make sure your antenna is connected securely to your HDTV and move the |
|
| antenna to an alternate location in the room or close to a window. |
Audio volume differs on |
| ∙ Your HDTV will retain the last used volume level for each input. |
each input |
|
|
Low audio volume (TV |
| ∙ Press the Volume up on the remote control. |
internal speakers) |
| ∙ Increase the volume of the external device using that device’s remote. |
|
| |
|
|
|
Distorted/popping audio |
| ∙ Check video/device cable integrity. Try another cable (HDMI, Component, |
|
| AV/Composite, Coax etc.) |
|
| ∙ Insure audio cables are tightly inserted into inputs. |
|
| ∙ Try another device. |
|
| ∙ Use another device input. |
|
|
|
Remote Control Troubleshooting | ||
|
|
|
Issue |
| Solution |
|
| ∙ Point the remote control directly at the remote sensor on your TV (IR mode |
The remote control will not |
| only). |
| ∙ Remove any obstacles between the remote control and the remote sensor (IR | |
work |
| |
| mode only). | |
|
| |
|
| ∙ Replace dead batteries with new ones. |
|
|
|
The remote control will not |
| ∙ Check the Advanced Audio menu located in the OSD. Audio control must be |
adjust TV Volume. |
| set to TV. |
Channel Up and Down |
| ∙ In the OSD select Tuner, then refer to TV Menu…Auto Search on Page 42 for |
buttons will not work. |
| more detail. This must be performed before attempting to change channels. |
Media Viewer Troubleshooting
Issue
USB device is not recognized.
Image or sound is interrupted or distorted.
Slideshow doesn’t start.
Solution
∙Make sure the device is correctly inserted.
∙Make sure the device is FAT or FAT32
∙Make sure it contains the supported files.
∙Make sure the device is correctly inserted.
∙Make sure that the file complies with the supported format, bit rate and/or profile. Also check the file for damage.
∙Some files that comply with the supported format may not play back or display properly.
∙Make sure the viewer isn’t in pause, rotation, or zoom mode.
74
www.VIZIO.com