system set up
This chapter describes the advanced settings that you can access from your Audio Server’s Set Up menu.
To access the Set Up menu:
•Press the JMenu key on your remote control to display the Main Menu.
•Use the Uand Vkeys to highlight the Set Up option.
•Press the OSelect key.
The following screen is displayed:
The following sections describe each of the options available from the Set Up menu.
Network Settings
This section allows you to specify how your Audio Server connects to the Internet.
Choose between Ethernet, Modem or None as the connection type and press the MSave key to commit any changes you make.
Specify DHCP as the Ethernet Mode if your Audio Server is connected to a network with a DHCP server present, and the Ethernet settings should be assigned automatically. Otherwise, choose Static and enter your own Ethernet details in the Static Ethernet Settings section.
Current Ethernet Settings
Allows you to view the current Ethernet settings being used by your Audio Server.
This menu is not editable and is used for reference only. See below for instructions about changing these settings.
Static Ethernet Settings
This section allows you to configure the Audio Server’s Ethernet settings.
Use this section to enter your own Ethernet details in the IP Address, Subnet Mask, Gateway and DNS fields. Again, be sure to press the MSave key to commit any changes you make.
Modem Settings
If you select Modem as your Internet Connection type you must then input your Internet Service Provider’s details on this screen.
24