Vizio RP56 Checking the Component Codes, Reassigning Component Buttons, Changing Volume Lock

VIZIO RP56 User Guide

Checking the Component Codes

If you have set up the Universal Remote Control using the “Searching for Component Code” procedure, you may need to find out which four-digit code is operating your equipment.

To find out which code is operating your TV:

1.Press the TV button once.

2.Press the hold the SETUP button until the LED blinks twice, then release the SETUP button.

3.Enter 9 9 0. After this number sequence has been entered the LED will flash twice.

4.To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (i.e., 3 blinks = 3) and write down the number.

Note: If a code digit is “0”, the LED will not blink.

5.Repeat step # 4 three more times for the remaining digits. Use 2 for the second digit. Use 3 for the third digit, and 4 for the fourth digit.

6.To check the codes for your other components, repeat steps 1 through 5, but substitute the appropriate key (i.e., AUX, CBL, VCR, SAT, CD, AMP, or DVD) for the component you are checking. As before, write down each four-digit code.

Reassigning Component Buttons

You can reassign the component buttons on the remote control if you have more than one of the same type of component.

Example:

If you are using the Universal Remote to control your cable (CBL), CD, DVD, TV and two VCRs, you can reassign the satellite (SAT) button as a second VCR button.

1.Press and hold the SETUP button until the LED flashes twice.

2.Press 9 9 2. After this number sequence has been entered the LED will flash twice.

3.Press the component button that you want (VCR) once, and then press the component button that you are reassigning (SAT) once. The SAT button is now reassigned and can be programmed as a VCR component button. See “Programming the Universal Remote Control” on pager 34.

Changing Volume Lock

The Universal Remote Control is set to control volume through your TV while in cable (CBL), DVD, satellite (SAT) and VCR component modes. Use the volume lock if you want to control the volume for all components through a specific component.

Example:

You want to control volume for all components through your tuner.

1.Press and hold the SETUP button until the LED flashes twice.

2.Press 9 9 3. After this number sequence has been entered the LED will flash twice.

3.Press the component button once that you want to control the volume (TNR). The LED flashes twice. Volume will now be controlled through the tuner for all components.

040330 35