Sencore manual Final User Control Adjustment, VP300 100 IRE Window pattern

5.Select the VP300 Window2 pattern and adjust the pattern level for 80-100 IRE. Most direct- view displays will track well up to 100 IRE, whereas many projection displays produce a better compromise tracking when adjusted at a lower IRE level.

Fig. 2 - VP300 100 IRE Window pattern

6. Adjust the drive/gain controls to obtain color balance at high brightness.

Note: If only two drive controls are available, select the missing color as your reference color in the ColorPro Delta RGB display window.

7.Re-select the Window1 pattern, readjust the pattern IRE level to produce approximately 1-2 footlamberts of luminance, and recheck/readjust the cutoff controls for the desired chromaticity coordinates.

8.Repeat steps 5-7 until the display’s color temperature remains relatively constant (tracks) over the full range of white window IRE levels.

Final User Control Adjustment

When the white balance adjustment is complete, perform a final adjustment of the display’s user controls (brightness, contrast, sharpness, color, and hue), as outlined in Appendix A

Page 29