Sencore VP300 manual Preparation for first time use, Battery Types Used, AC Power Supply

Sencore VP300 manual Sencore Drive, Sioux Falls, SD Sencore VP300 manual Table of Contents Sencore VP300 manual Specifications Sencore VP300 manual Preparation for first time use, Battery Types Used, AC Power Supply, Battery Installation Sencore VP300 manual Making Connections Sencore VP300 manual Front Panel Controls and Indicators, LCD Window Sencore VP300 manual Signal Type, Format, and Pattern Menus, Signal Type Menu, Format Menu Sencore VP300 manual Pattern Description and Usage, Smpte Bar, Pluge Sencore VP300 manual Needle Sencore VP300 manual Horizontal Staircase H Stair Sencore VP300 manual Crosshatch, Overscan Sencore VP300 manual Anamorphic Sencore VP300 manual Window1, Window2, Raster Sencore VP300 manual Color Bar, Split Bar Sencore VP300 manual Focus, Ramp Sencore VP300 manual Regulate, Checker, Ansi Gray Sencore VP300 manual Multiburst Sencore VP300 manual Gating and Test Menus, Gating Menu Sencore VP300 manual Sequence and Burn-In Sub-Menus, Sequence Sub-Menu, Burn-in Sub-Menu Sencore VP300 manual Freq Shift, Audio, and DDC Step Sub-Menus, Freq Shift Sub-Menu, Audio Sub-Menu Sencore VP300 manual Color Pro Sub-Menu, ColorPro Sub-Menu Sencore VP300 manual Learn Formats Function and Options Menu, Details Sencore VP300 manual Appendix a Calibrating TV User Controls, Brightness Control, 3.5 IRE, 10 IRE Sencore VP300 manual Sharpness Control Sencore VP300 manual Contrast Control Sencore VP300 manual Color And Tint Controls, Color Control Sencore VP300 manual
Page 4

Preparation for first time use

Battery Types Used

The Model VP300 generator is supplied with four (4) internal size AA rechargeable Nickel Metal Hydride (NiMH) cells. These 1500 mA/H rated cells will operate the generator for about 8 hours on a full charge. They can normally be recharged about 1000 times before needing replacement. No other type of rechargeable battery can be used in the generator!

You can use non-rechargeable alkaline AA cells with the generator, provided that you never use the external power supply with the generator while the alkaline cells are in the unit. Attempting to operate the generator or recharge the alkaline cells with the external power supply may cause operator injury and/or damage to the generator! Never mix battery types in the generator.

AC Power Supply

The AC power supply that comes with the generator has an input voltage range of 100-240 VAC from 47 to 63 Hz. The output is rated at 9.0 VDC @ 1.67 Amp. This is sufficient to operate the generator and recharge the batteries at the same time. Attempting to operate the generator or recharge the batteries with any other type of external power supply may cause operator injury and/or damage to the generator!

Battery Installation

1)Place the generator face down on a suitable padded surface.

2)Remove the two back cover screws shown in the top figure.

3)Lift the back cover off the generator and locate the four battery holders, as shown in the middle figure.

4)Install the batteries, making sure to match up their polarities for each battery holder. The supplied batteries may not have any printed polarity indication. The outer metal can is the negative terminal. The insulated metal button, as shown in the end view in the lower figure, is the positive terminal.

5)Replace the back cover and retaining screws.

6)When the generator is shipped from the factory, the supplied batteries may not be fully charged. Connect the supplied AC power supply and charge the batteries for at least 8 hours.

Low Battery Indication

A "BATTERY LOW" message blinks on the LCD when the NiMH batteries need recharging or alkaline cells need replacement.

Page 3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents VP300 Sencore Drive, Sioux Falls, SDTable of Contents Specifications Battery Types Used AC Power SupplyBattery Installation Low Battery IndicationMaking Connections LCD Window Front Panel Controls and IndicatorsControls Signal Type, Format, and Pattern Menus Signal Type MenuFormat Menu Pattern MenuSmpte Bar Pattern Description and UsagePluge Needle Staircase Horizontal Staircase H StairCrosshatch OverscanAnamorphic Window1, Window2 RasterColor Bar Split BarFocus RampChecker RegulateAnsi Gray Multiburst Gating Menu Gating and Test MenusTest Menu Sequence Sub-Menu Sequence and Burn-In Sub-MenusBurn-in Sub-Menu Freq Shift, Audio, and DDC Step Sub-Menus Freq Shift Sub-MenuAudio Sub-Menu DDC Step Sub-MenuColor Pro Sub-Menu ColorPro Sub-MenuLearn Formats Function and Options Menu Learn Formats FunctionDetails Options MenuAppendix a Calibrating TV User Controls Brightness Control3.5 IRE 10 IRESharpness Control Contrast Control Color And Tint Controls Color ControlPage Page Appendix B Video Display White Balance Adjustment White Balance AdjustmentFinal User Control Adjustment VP300 100 IRE Window patternSioux Falls, SD Sencore DriveCall 1-800-SENCORE
Top Page Image Contents