Component video outputs/inputs

PROGRESSIVE outputs/inputs

Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned video signal. Connecting to these inputs allows you to view the highest quality pictures with less flicker.

INTERLACED outputs/inputs

Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest quality DVD picture playback.

Connecting to an audio system and TV equipped with component video inputs

Signal flow

To Y	To PB	To PR
VIDEO	VIDEO	VIDEO
OUT	OUT	OUT

OUT PUT

COMPONENT		DIGITAL
Y
S-VIDEO
PB	L	COAXIAL
OPTICAL	AUDIO
PR	R	VEDIO

To AUDIO OUT

(red) (white)

Audio cable (not supplied)

To audio inputs

of the amplifier

(red) (white)

If the TV has the Component input, connect the DVD video player with the Component cable. When using the Component cable, do not connect the yellow video cable. Set the COMPONENT/S-VIDEO selector switch to the COMPONENT position.

To wall outlet

Audio system

Component video cable (not supplied)

To PR video input

To PB video input

To Y video input

TV or monitor with ColorStream® component video inputs

Notes:

•Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)

•In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV or monitor for optimum performance.

Notes:

•Refer to the owner’s manual of the connected equipment as well.

•When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

•If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD video player away from the tuner and radio.

•The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

•Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power on, the speakers may be damaged.

•When connecting to a TV using the Video or S-video jack, do not set the COMPONENT/S-VIDEO selector switch to the COMPONENT position and make the Progressive scan mode On with the PROGRESSIVE button. If you do it, the Video and S-video outputs do not feed the correct signals and you cannot see any picture. To turn off the Progressive scan mode, select PROGRESSIVE scan Off (see page 32).