Toshiba HD-EP30KE Clock Set, OSD On/Off, Remote Controller Sound, Hdmi Control REGZA-Link, Update

Clock Set

See page 19.

OSD On/Off

To activate or deactivate the operational status display on the TV screen.

On

Off

Activates the operational status display (e.g., ) on the TV screen.

Deactivates the operational status display (e.g., ) on the TV screen.

Remote Controller Sound

To turn on or off the confirmation beeper announcing when each remote command is received.

On

Off

Turns on the beep sound.

Turns off the beep sound.

HDMI Control (REGZA-Link)

To turn on or off the features offered with CEC (Consumer Electronics Control) when an HDMI device is connected to this player. Use of HDMI Control which is a feature based on HDMI-CEC requires an HDMI-CEC compatible display device.

Enable HDMI	Select “On” to control this player using the remote control of your TV.
control	To disable this function, select “Off”.
OneTouchPlay	(Only when “Enable HDMI control” is set to “On”)
	Select “On” to turn the connected TV on if it is off and set its input to the player automatically to display the
	player’s picture, by pressing one of (PLAY), MENU, RESUME PLAY, TOP MENU buttons.
	To disable this function, select “Off”.
SystemStandby	(Only when “Enable HDMI control” is set to “On”)
	Select “On” to turn off both the player and the connected TV from the TV’s remote control.
	To disable this function, select “Off”.

When complete, select “OK” then press OK button.

Notes

•Depending on the specifications of your TV, this function does not work even when your TV is HDMI-compatible.

•All the above features may not always work on all compatible TVs.

Maintenance

Initialize	To reset all the settings listed on		page 30, 31 to factory set default.
	Press / buttons to select “Yes” then press OK button.
Update (Firmware	If you have a broadband internet service, you may obtain firmware update over the internet using the LAN
update)	port on the back of your player.
	•	BEFORE BEGINNING THE FIRMWARE UPDATE PROCESS, BE SURE TO REMOVE ANY DISCS
		FROM YOUR PLAYER.	page 17). You may need to turn on DHCP and DNS ( page 22).
		Please configure the LAN port (
	•	Press SETUP and select “General” > “Maintenance”. Follow the instructions on the screen.
	•	If a firmware update is available for your player, the player will download it. Once the firmware update
		dowload process has finished, the player’s power will automatically switch off. You must wait until this
		process has finished.
	•	DO NOT UNPLUG, TURN OFF, OR USE ANY OTHER FEATURE OF YOUR PLAYER DURING THE
		FIRMWARE UPDATE PROCESS. Doing so will cause the writing of the firmware update to the player
		to be halted and the player may no longer operate properly. If the player stops working, please contact
		Toshiba customer service for your country or http://www.highdefinitiondvd.eu/.
	•	If no fimware update is available, the player will quickly exit the firmware update process.

Persistent Storage To open the menu to control player’s memory allocated for content. (Not available while a disc is loaded.) The menu selections will vary depending on the content. Operate following the instructions displayed on your screen.

Twin Format Disc

To select a layer to play, HD DVD or DVD of an HD DVD Twin Format Disc. (Not available if a disc is loaded.)

HD DVD	Only the HD DVD layer is played.
DVD	Only the DVD layer is played.

Note

• For combination discs, select the desired version by disc side (see label for information).

35

HD-EP30KE_Eng.indd 35

07.9.3 2:02:05 PM