Toshiba MV13P2 owner manual Battery Installation, Battery Precautions, Feet

Page 12

REMOTE CONTROL

BATTERY INSTALLATION

1

Slide the battery compart-

2

Install two “AAA” batteries,

ment cover in the direction

paying attention to the

 

of the arrow.

 

polarity diagram in the

 

 

 

battery compartment.

 

 

 

 

BATTERY PRECAUTIONS

(CONTINUED)

3

Replace the compartment

cover.

 

 

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (Follow battery manufacturer’s directions).

EFFECTIVE DISTANCE OF THE REMOTE CONTROL

15 FEET

NOTES: When there is an obstacle between the TV/VCR and the remote control, the remote control may not operate.

When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the Remote sensor of the TV/VCR, the remote operation may be unstable.

When using the remote control, press the button at intervals of about 1 second to ensure the correct mode of operation.

10

5L80101C P10-19

10

20/4/04, 16:19

Image 12
Contents TV/CABLE Mode Selection MV13P2Risk of Electric Shock Do not Open Cleaning AccessoriesPower Source Grounding or Polarization Read InstructionsPOWER-CORD Protection Power LinesReplacement Parts LightningSafety Check HeatNEC Section Features Table of Contents Safety Precautions When YOU Experience the Above ConditionsMoisture Condensation Moisture will Condense on the Unit in the Following CasesPower Source To USE AC PowerWider Hole and Blade AC Outlet Location of Controls Front RearDescription of Controls FrontRemote Control Cursor Selects an item in the menuSpeed button Sets the tape speed for recording Battery Installation Battery PrecautionsEffective Distance of the Remote Control FeetAntenna Connections JackOhm matching transformer Antenna Jack Combiner UHF 300 ohm VHF 300 ohmFor Subscribers to Basic Cable TV Service For Subscribers to Scrambled Cable TV ServiceCable TV Connections Starting Setup EnterSetting the Language Auto Clock Setting Auto Clock SettingAuto Clock Adjustment To SET Auto Clock to OFFAuto for automatic setting read EDS in the signal Press MENU. Press Bor a to select optionPress or to select Daylight Saving TIME, then press a Menu screen is clearedManual Clock Setting Press Bor Ato setMonth, then press As in , then pressPress Power Adjust the volume level byTV Operation Cable TV ChannelsCall MuteChannel + MuteClosed Caption Channel Return SleepSleep Closed CaptionWhat is Closed CAPTIONING? Closed Captioning with a VCRTo View Closed Captions Cable TV chart To Memorize ChannelsTV/CABLE Selection Automatic Memory Tuning Then press aNumbers will remain red until auto memorizing is complete To ADD/DELETE Channels Channel selectionSetting the V-CHIP To Register PasswordEnter the same password Using Direct channelTo SET the V-CHIP Enter To use the TV after the TV is protectedTo Change Password To SET the on Timer Press B or Ato select ON/OFF TIMER, thenOn TIMER, then press a Option Press aTo SET the OFF Timer Press Bor Ato selectOption Press a Picture Control Adjustments CancelSelection Pressing Adjusting the Picture Preference Mode Picture QualityPress B or a to select option PREFERENCE, then press a Press or to select the desired pictureAutomatic Power on and Play Loading and Unloading a Video CassetteLoading UnloadingTo Prevent Accidental Erasure To Record Again Tape Speed and Maximum PLAYBACK/RECORDING TimeSP Standard Play Playback To Start PlaybackStop To Stop PlaybackDigital Tracking Controls REWTo Rewind or Forward the Tape Rapidly FORWARD/REVERSE Picture SearchSpecial Playback StopSkip Search PAUSE/STILLOver until the repeat mode is canceled To Watch a Tape RepeatedlyPress Bor Ato select on Recording a TV Program Recording and Viewing the Same TV ProgramScreen and the REC indicator will light To Stop Recording To Stop Recording TemporarilyPress Direct channel selection 0-9orCH + Ple ChannelONE-TOUCH Timer Recording OTR Press Direct channelTimer Recording Press or to select Timer REC SETPosition, then press Enter Press the or to select the programTimer REC indicator will light Speed as in stepPress Enter Steps 3 to 6 to set the second programOther Functions for the Timer Recording CancelTo Cancel a Program If the Program ProgramUsing the Real Time Tape Counter To View the Counter DisplayDisplay the elapsed time Using Zero Return Before playback or recording, press000000 Press Zero ReturnTV Monitor To Monitor a TV ProgramIndex search Duplicating a Video Tape Connection to Another VCRConnection to Camcorder Reception Disturbances Problem and Troubleshooting Guide Check the following chart before requesting serviceSymptom Cause Possible Solution Power No powerSymptom Cause Possible Solution Remote ControlDepressed To turn on the closed caption RecordingVideo Head Cleaning Video Head CleaningVideo Head Clogging TelevisionLimited Ninety 90 Day Warranty Limited One 1 Year WarrantyLimited Two 2 Year Warranty of Picture Tube Rental UnitsHow to Obtain Warranty Service Toll FreeContinental United States contact 04/04 U