Toshiba MV13P2 owner manual Antenna Connections, Jack, Ohm matching transformer

Page 13

ANTENNA CONNECTIONS

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a cable TV service (CABLE), see page 12 for Cable TV connections.

Combination VHF/UHF antenna (Single 75 ohm cable or 300 ohm twin-lead wire)

ANT.

ANT.

Antenna

Antenna

jack

jack

75 ohm

 

coaxial

300-75 ohm

cable

matching

 

transformer

Connect the 75 ohm cable from the combination VHF/ UHF antenna to the antenna jack.

If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, the use of the 300-75 ohm matching transformer may be necessary.

Combination VHF/UHF antenna (Separate VHF and UHF 300 ohm twin-lead wires)

ANT.

300-75 ohm matching transformer

Connect the UHF 300 ohm twin-lead wire to the combiner (not supplied). Connect the VHF 300 ohm twin-lead wire to the 300-75 ohm matching trans- former. Attach the transformer to the combiner, then attach the combiner to the antenna jack.

Antenna

jack

Combiner

UHF 300 ohm

VHF 300 ohm

Separate VHF/UHF antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)

Connect the VHF 75 ohm cable and UHF 300 ohm twin-lead wire to the combiner (not supplied). Attach the combiner to the antenna jack.

ANT.

Antenna

jack

Combiner

VHF 75 ohm

UHF 300 ohm

11

5L80101C P10-19

11

20/4/04, 16:19

Image 13
Contents MV13P2 TV/CABLE Mode SelectionRisk of Electric Shock Do not Open Accessories CleaningPower Source Grounding or Polarization Read InstructionsPower Lines POWER-CORD ProtectionReplacement Parts LightningHeat Safety CheckNEC Section Features Table of Contents When YOU Experience the Above Conditions Safety PrecautionsMoisture Condensation Moisture will Condense on the Unit in the Following CasesTo USE AC Power Power SourceWider Hole and Blade AC Outlet Front Rear Location of ControlsDescription of Controls FrontCursor Selects an item in the menu Remote ControlSpeed button Sets the tape speed for recording Battery Precautions Battery InstallationEffective Distance of the Remote Control FeetJack Antenna ConnectionsOhm matching transformer Antenna Jack Combiner UHF 300 ohm VHF 300 ohmFor Subscribers to Scrambled Cable TV Service For Subscribers to Basic Cable TV ServiceCable TV Connections Enter Starting SetupSetting the Language Auto Clock Setting Auto Clock SettingAuto Clock Adjustment To SET Auto Clock to OFFPress MENU. Press Bor a to select option Auto for automatic setting read EDS in the signalPress or to select Daylight Saving TIME, then press a Menu screen is clearedPress Bor Ato set Manual Clock SettingMonth, then press As in , then pressAdjust the volume level by Press PowerTV Operation Cable TV ChannelsMute CallChannel + MuteSleep Closed Caption Channel ReturnSleep Closed CaptionClosed Captioning with a VCR What is Closed CAPTIONING?To View Closed Captions To Memorize Channels Cable TV chartTV/CABLE Selection Then press a Automatic Memory TuningNumbers will remain red until auto memorizing is complete Channel selection To ADD/DELETE ChannelsTo Register Password Setting the V-CHIPEnter the same password Using Direct channelTo SET the V-CHIP To use the TV after the TV is protected EnterTo Change Password Press B or Ato select ON/OFF TIMER, then To SET the on TimerOn TIMER, then press a Option Press aPress Bor Ato select To SET the OFF TimerOption Press a Cancel Picture Control AdjustmentsSelection Pressing Mode Picture Quality Adjusting the Picture PreferencePress B or a to select option PREFERENCE, then press a Press or to select the desired pictureLoading and Unloading a Video Cassette Automatic Power on and PlayLoading UnloadingTape Speed and Maximum PLAYBACK/RECORDING Time To Prevent Accidental Erasure To Record AgainSP Standard Play To Start Playback PlaybackStop To Stop PlaybackREW Digital Tracking ControlsTo Rewind or Forward the Tape Rapidly FORWARD/REVERSE Picture SearchStop Special PlaybackSkip Search PAUSE/STILLTo Watch a Tape Repeatedly Over until the repeat mode is canceledPress Bor Ato select on Recording and Viewing the Same TV Program Recording a TV ProgramTo Stop Recording To Stop Recording Temporarily Screen and the REC indicator will lightPress Direct channel selection 0-9orCH + Ple ChannelPress Direct channel ONE-TOUCH Timer Recording OTRPress or to select Timer REC SET Timer RecordingPosition, then press Enter Press the or to select the programSpeed as in step Timer REC indicator will lightPress Enter Steps 3 to 6 to set the second programCancel Other Functions for the Timer RecordingTo Cancel a Program If the Program ProgramTo View the Counter Display Using the Real Time Tape CounterDisplay the elapsed time Before playback or recording, press Using Zero Return000000 Press Zero ReturnTo Monitor a TV Program TV MonitorIndex search Connection to Another VCR Duplicating a Video TapeConnection to Camcorder Reception Disturbances Check the following chart before requesting service Problem and Troubleshooting GuideSymptom Cause Possible Solution Power No powerRemote Control Symptom Cause Possible SolutionDepressed To turn on the closed caption RecordingVideo Head Cleaning Video Head CleaningVideo Head Clogging TelevisionLimited One 1 Year Warranty Limited Ninety 90 Day WarrantyLimited Two 2 Year Warranty of Picture Tube Rental UnitsToll Free How to Obtain Warranty ServiceContinental United States contact 04/04 U