HOW TO OPERATE
1
Preparing Song Files
A. Encoding Audio CD or CD+G discs
Encoding of song files from audio CD or CD+G discs can be done in two ways:
*directly in
*using
Note: Encoding a CD+G disc requires a CD+G compatible disc drive connected to
Note: For instruction on how to encode a CD or CD+G discs directly in
The files encoded directly in
Using
-Start the program and click on CDG ENCODER.
-Insert the CD or CD+G disc into the disc drive and close the tray.
-Press SOURCE DRIVE button to select a disc drive, if there is more than one, which contains the disc.
-Press READ TOC button to display the tracks of the disc in the left side panel.
-Press Target button to select a directory in which the encoded files will be stored.
-Select a track you wish to encode by placing a check mark and inputting a title. If you wish to select all, press the Check All button and input a title.
Note: The files encoded will be named as the inputted titles. Assign a different title to each track to avoid overwriting.
-Select a disc drive speed at which the disc will be read.
-Select the compression rate at which the audio data will be encoded. Normally it is set at 128Kbps.
-Select the Sync timing of lyric display relative to the music. The 75 frames is equivalent to 1 second. Normally it is set at 0.
-Check the Send Graphic Files button, indicating both audio and graphics are to be encoded. For audio CD, do not check the Send Graphic Files button.
-Press Encode button to start encoding.
The right side panel will display the extracted files as follows:
Title1 | MP3 |
|
Title1 | CDG | (for CD+G disc only) |
Title2 | MP3 |
|
Title2 | CDG | (for CD+G disc only) |
64