Toshiba 32AV600E owner manual Troubleshooting, Symptom and solution

Page 32

Reference section

Troubleshooting

Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions.

Symptom and solution

TV will not turn on

Make sure the power cord is plugged in, then press ! or 1.

The remote control batteries may be dead. Replace the batteries.

No picture, no sound

• Check the aerial connections.

No sound, picture OK

• The sound may be muted. Press I, i or .

The station may have broadcast diffi culties. Try another channel.

Poor sound, picture OK

The station may have broadcast diffi culties. Try another channel.

Poor picture, sound OK

Check the aerial connections.

The station may have broadcast diffi culties. Try another channel.

Adjust the PICTURE menu.

Poor reception of broadcast channels

Check the aerial connections.

The station may have broadcast diffi culties. Try another channel.

Make sure the Colour system is properly set.

Teletext problems

Check the aerial connections.

Good performance of text depends on a good strong broadcast signal.

Some pixels of the screen do not light up

The LCD display panel is manufactured using an extremely high level of precision technology, however, sometimes some pixels of the screen may be missing picture elements or have luminous spots. This is not a sign of a malfunction.

The brightness of the screen comes down, or flickers of the screen are caused, or some parts of the screen do not light up.

When you just buy and start to use this TV, a fl ickering may be caused in the screen. In this case, switch off the TV, then switch on it again to cure the condition.

The cold cathode fl uorescent lamp used for the back light on this TV has longevity. When the brightness of the screen comes down, or the fl ickers of the screen are caused, or some parts of the screen do not light up,

it may reach the end of its life. Contact a service technician.

The picture brightness varies when you display switch the TV on.

If you switch the TV on at 0°C and under, wait until the warms up.

Multiple images

The station may have broadcast diffi culties. Try another channel.

Aerial reception may be poor. Use a high directional outdoor aerial.

Check if the direction of the aerial has changed.

Poor colour or no colour

The station may have broadcast diffi culties. Try another channel.

Adjust the Tint and/or Colour in the PICTURE menu.

The remote control does not operate

Remove all obstructions between the remote control and the remote control sensor on the TV.

The remote control batteries may be dead. Replace them with new ones.

32

Image 32
Contents LCD Colour TV Contents Important Safety Instructions InstallationNever insert or remove the power plug with wet hands Welcome to ToshibaPrecautions for moving the TV Side viewNever block or cover the slots and openings in the cabinet Never place the TV near a heater or in direct sunlightHigh temperatures can melt plastic and lead to fi res UseNever repair, modify or disassemble the TV by yourself ServiceContact a service technician for inspection and repair Exemptions CleaningImportant information Connecting an aerial Installing the remote control batteriesExploring your new TV Effective rangePower on/Standby Press to turn the TV on/ standby Menu left/right When a menu isTV front and side panel controls TV front viewPC/HDMI1 Audio input terminals TV back panel connectionsHDMI2 input terminal High Learning about the remote control Location of controlsSwitching on the TV Displaying the menu chartSwitching off the TV Turning the TV onSwitching between two programme positions Watching TV programmesSelecting the menu language Changing the programme positionManually setting channels in the channel memory Programming channels into the TV’s channel memoryProgramming channels automatically Programme position selection Sound system Colour systemMFT Manual Fine Tuning Sorting programme positionChannel search operation LabelPicture adjustment Selecting the picture sizeUsing the picture still Adjusting the picture positionResetting the picture position Press I or i to adjust the settings as requiredSelecting the picture mode Adjusting the basic picture qualityActivating the black/white level Activating the Mpeg NR Noise ReductionSelecting the colour temperature Adjusting the colour managementResetting the base colour adjustment Using the active backlight controlSound adjustment Selecting the dual 1 or dual 2 modeAdjusting the sound quality Selecting the stereo programmesUsing the bass boost Using the remote control Using the bass boostSelecting the surround sound SelectionOther features settings Setting the manual setting menu Setting up the teletext modeSelecting the video input source to view TeletextUsing Auto mode To select teletext modeTeletext general information Text buttonUsing List mode Teletext buttons on the remote controlConnecting an Hdmi and a DVI device Back connectionsConnection example Connection exampleConnecting an Hdmi device Connecting a DVI deviceConnecting an Hdmi and a DVI device Hdmi type a connector-to-DVI adapter cableSetting the HDMI1 audio mode Setup menuSelecting the Lip Sync Press MENU, then press I or i to displayConnecting a computer Following signals can be displayedSignal names for mini D-sub 15 pin connector Pin No Signal nameTo connect a PC to the Hdmi terminal on the TV Using the PC settingAdjusting the picture size/position Resetting the PC setting Adjusting the clock phase of the pictureAdjusting the sampling clock Troubleshooting Symptom and solutionBroadcast system Broadcast transmission systems of each country or regionSpecifications LCD colour televisionSupplied accessories