Toshiba 36HF12 owner manual Using the Locks menu, Entering the PIN code

Page 30

Using the TV’s Features

Using the LOCKS menu

The LOCKS menu includes the V-Chip, CH Lock, Video Lock, and New PIN Code functions. You can use these functions after entering the correct PIN code.

Entering the PIN code

1.Press MENU, and then press x or • until the LOCKS menu appears.


		LOCKS
V-CH I P
	ENABLE BLOCK I NG									OFF
	TV RAT I NG
	MPAA RAT I NG
	BLOCK I NG OPT I ON
CH LOCK
V I DEO LOCK										OFF
FRONT PANEL LOCK										OFF
NEW P I N CODE

2. Press y or z to display the PIN code entering mode.

• Blocking Reset status:

• When the PIN code is already stored:

Set your 4-digit code by pressing

Press the Number buttons (0-9) to enter

the Number buttons (0-9), and

the 4-digit PIN code used for blocking

then press ENTER.

channels, and then press ENTER.

LOCKS	LOCKS
BLOCK I NG RESET	BLOCK I NG ACTIVE
P I N CODE 11 10	P I N CODE 12 34

If a wrong PIN code is entered, the message “Incorrect” appears. Enter the code again, and then press ENTER.

If you cannot remember the PIN code, while in the PIN code entering mode, press the RECALL button four times within five seconds. The PIN code will be released (Blocking Reset status restored).

LOCKS

V- CH I P

ENABLE BLOCK I NG

ON /

OFF

TV RAT I NG

MPAA RAT I NG

BLOCK I NG OPT I ON

CH LOCK

V I DEO LOCK

OFF

FRONT PANEL LOCK

OFF

NEW P I N CODE

Continue to set each item following the steps on the next page.

Note:

The V-Chip function is available only for the U.S. V-Chip system. The Canadian V-Chip system is not supported.

LIGHT RECALL POWER

TV

CABLE MUTE TV/VIDEO TIMERRECALL VCR

	1	2	3
				CH
	4	5	6	Number
	7	8	9	Number
	7	8	9
			CH RTN VOL
	100	0	ENT
			ADV/
	FAVORITE	PIP CH		PIC
	FAVORITE			PIC
				SIZE

MENU/ENTER

FAV		MENU/		FAV
		ENTER
				yzx •

STROBE		ADV/		EXIT
		PIP CH
STOP SOURCE			PLAY PIP
	REC TV/VCR		REW	FF
		STILL	LOCATE	SWAP

30

Image 30

Contents 36HF12 Safety Precautions Dear CustomerImportant Safety Instructions InstallationService CareIntroduction Welcome to Toshiba IntroductionPlease Note Exploring your new TVConnecting your TV Connecting a VCRConnecting your TV Connecting a cable converter boxConnecting a cable converter box and VCR From CableUsing Connecting a DVD player or satellite receiver and a VCRIntroduction Connecting YourTV Control Settingup YourTV UsingtheTV’s Features Appendix IndexDVD player with component video Antenna Introduction Connecting YourTV Usingthe RemoteControlFrom DTV receiver with component videoFrom Antenna Connecting two VCRsConnecting a camcorder CamcorderSettingup YourTV Connecting an audio systemConnecting an A/V receiver To A/V ReceiverInstalling the remote control batteries Using the remote controlPreparing the remote control for use Using the remote control with a VCR or cable TV converterVCR2 and reprogram the remote control VCR code table Brand name Code numberCable TV converter code table ABCLearning about the remote control Exit exits programming menusUsingthe RemoteControl Settingup YourTV Setting up your TVIntroduction Connecting YourTV UsingtheTV’s FeaturesSelecting the antenna input Setting up your TVChanging the on-screen display language Press x or to highlight your desired languageAdding and erasing channels manually Adding channels to the TV’s memoryProgramming channels automatically Press z to select CH ProgramChanging channels Adjusting the tilt correction featureChanging channels using SpeedSurf Press y or z to highlight ADD/ERASESwitching between two channels Using the TV’s featuresAdjusting the channel settings Programming your favorite channelsUsing the TV’s Features Labeling channelsMENU/ENTER Picture tube than in the Compression mode Viewing the wide-screen picture formatsSelecting the image shape Example PIP mode Setting YourTV UsingtheTV’s Features AppendixPIP mode Watching PIP/double-windowExample PIP mode Still Switching the main and sub-picturesPIP mode Double-window mode Changing the position of the small pictureUsing the strobe function Using the multi-window featureUsing the favorite function Setting Your UsingtheTV’s FeaturesEntering the PIN code Using the Locks menuPress y or z to display the PIN code entering mode Continue to set each item following the steps on the nextUsing the V-CHIP menu Usingthe RemoteTV Rating Independent rating system for broadcasters Mpaa Rating Independent rating system for movies Press x or to return to the Locks menuLocking channels Unlocking programs temporarilyRepeat steps 3 and 4 for other channels Locking video inputs Press y or z to highlight Clear ALL, and then press x orPress Enter New PIN code is now active Using the front panel lock featureChanging the PIN code Buttons to be lockedAdjusting the picture Selecting the picture modeAdjusting the picture quality To turn off the DNR feature Highlight OFF in above Using the flesh tone featureUsing the Digital Noise Reduction DNR feature Saving new preferenceSelecting the cinema mode Selecting the color temperatureResetting picture adjustments Connecting YourTV Control Selecting the video input sourceLabeling the video input sources Using the closed caption feature To view text, highlight T1, T2, T3, or T4Setting the sleep timer Setting the clockTo set the clock Adjusting the sound Muting the soundSelecting stereo/SAP broadcasts Using the SRS 3D surround sound feature Adjusting the sound qualityResetting audio adjustments Using the sub-bass system SBSTo turn off the SBS Highlight OFF in above Turning off the built-in speakers Selecting the Audio OUT soundTo turn on the built-in speakers Highlight on in above Using the StableSound feature Selecting the background of the menu displayDisplaying on-screen information Viewing the demonstration mode Understanding the auto power off featureUnderstanding the last mode memory feature Specifications AppendixBlack box appears on the screen TroubleshootingAntenna T2, T3, or T4. Turn closed captioning OFFLimited United States Warranty Limited Canada Warranty Index Channel programmingPage Manufactured by